P.S. 콘크리트 보의 비선형 최적설계

정철원,최규문,손용우 圓光大學校 1994 論文集 Vol.28 No.2

비선형 최적설계법을 개발하였다. 이 방법의 목적은 PC구조물의 극한에서 나타나는 거동을 예측하는 것이다. 그에 따른 주요결과를 제시하였고 콘크리트와 강의 실제 거동의 실험 과정에서 겪는 난점을 거론하였다. 특히 PC강선에서 이용가능한 다양한 응력-변형 관계를 비교하고 실제 특성에서 나타난 차이점을 관찰하였다. 그 관계들에 관하여 추천된 식들의 해당계수를 제시하였다. 그 결과는 PC강선의 종류와 양, 비 프리스트레스 인장과 압축철근의 양, 극한 콘크리트압축변형 등과 같은 주요 변수들의 극한 거동에서 영향이 나타난다는 것이다. 그 영향과 결과를 유도한 규준을 비교하는 데에 중점을 두었다. 이 연구에서 얻은 결과들로써 만약 추천된 규준을 사용하는 경우에 그 규준이 불안정한 설계를 유도할 가능성이 있는 부분과 또 관찰된 경향에 알맞게 규준을 수정하기 위하여 필요한 점을 지적할 수 있게 되었다. An approximate nonlinear design procedure is development. It is the aim of the procedure to predict the behavior at ultimate of prestressed and partially prestressed concrete members. We showed the main results and discussed some difficulties which we come (on in) simulating the actual behavior of concrete and steel. Especially the various available stress-strain relationships for prestressing steels are compared and variability in their actual properties is observed. Corresponding coefficients of recommended equations are given. It is the result that the influence on ultimate behavior of major variables such as type and amount of prestressing steel, the amount of nonprestressed tensile, compressive reinforcement, and the ultimate concrete compressive strain exists. Then we put an empasis on comparing the influence with code derived results. By results of this study, we could point out that if used. where the recommended code may lead to an unsafe design and what modifications may be needed to make the code suitable to the observed trends.

鐵筋콘크리트 構造物의 最適設計

鄭哲源,朴熙淳,孫鎔雨,崔圭文 圓光大學校 1989 論文集 Vol.23 No.2

이 論文에서는 最適化問題를 해결한다 : 彈牲設計에 비해 最大效率로 주어진 形態의 構造를 設計하여 모든 可能한 荷重組合下에서 그 構造의 崩壞와 그것의 臨界斷面의 first yield에 대한 어떤 지정된 最小荷重係數를 측정한다. 目的函數를 線形化하고, 모든 limit equilibrium constraint를 算出해 내는 方法을 개발하여 線形計劃法과 콤퓨터技法의 도움으로 그 問題를 해결한다. 관계되는 원리와 대응되는 最適解는 鐵筋콘크리트 連續보와 뼈대 構造를 例로서 설명되어 있다. The following optimization problem is solved in the paper : design a structure of given geometry for maximum efficiency vs. elastic design, so that under any possible load combination certain specified minimum load factors be guaranteed against both the collapse of the structure and the first yield of its critical sections. By linearizing the objective function and developing a method to generate all limit equilibrium constraints the problem is solved with the help of linear programming and computer techniques. The principles involved and corresponding optimal solutions are illustrated by the examples of a reinforced concrete continuous beam and frame.

Study on the Establishment of Free Trade Zone Agricultural Tariffs in China, Japan and South Korea Based on the GTAP Model

Kou Zheng,Kou Lianxiang,Yang Honghong 한중경제문화학회 2019 한중경제문화연구 Vol.12 No.-

Tariff Policy and Environmental Qualities of Imported Goods

Kou, Horn-In,Hu, Jin-Li,Hwang, Hong 세종대학교 국제경제연구소 2001 Journal of Economic Integration Vol.16 No.3

Tariff is a trade measure with both of the trade and environmental effects. This article analyzes the interaction between the tariff rate and the short and long run environmental qualities of imperfectly substitutive imported goods. In the first part, we analyze the effect of changing the tariff rate on the environmental qualities of imported goods. That is, the import country government sets up the tariff rate before the foreign exporters choose their environmental qualities. If improving environmental qualities reduces the rate of decrease of consumers' marginal utilities, then a reduction in the tariff rate results in higher environ-mental qualities; moreover, the long run environ-mental qualities of imported goods will be higher. In the second part, we discuss the effect of environmental quality improvement on the optimal tariff. That is, the foreign exporters choose their environmental qualities before the home country government sets up the tariff rate. When the consumers are not environmentally conscious, whether the importance of environmental qualities is emphasized or not, it is optimal for the government to impose a lower (higher) tariff rate on the high low) environmental quality imported goods. If the environmental quality improvement cost is sufficiently higher than the marginal pollution abatement and/or marginal environmental damage, or if the import country government emphasizes environmental qualities, then the long run tariff rate on high environmental quality imported goods should be lower than that of the short run tariff.

Study on the Coordinated Development of Pudong Airport Logistics and Regional Economy

Kou Zheng,Li Xi,Zhang Man 한중경제문화학회 2018 한중경제문화연구 Vol.11 No.-

China’s aviation cargo transportation has developed rapidly in recent years, airport logistics is the outcome of modern logistics and high-efficiency of traditional aviation cargo transportation. Because of the speed, convenience and safety of airport logistics, people increasingly tend to use airports to carry out activities in all aspects of logistics, the demand for airport logistics has exploded, and airport logistics has become an important factor to be considered in airport planning and later development now. The development of airport logistics has created the airport economy, the rise of the airport economy has become a new growth pole of the regional economy. At present, the construction of high-speed rails has caused bottlenecks in the development of aviation cargo transportation, and the advantages of airport logistics have been greatly weakened, therefore, airport logistics must find a solution out. Therefore, on the basis of summarizing the relevant literature, this article closely links airport logistics with related local industries, and seeks a new way for the coordinated development of airport logistics and regional economy. This article takes the Pudong New Area and Pudong Airport as examples to explore the driving factors for mutual boosting development between airport logistics and regional economy. Based on this, select Granger causality test to prove the causality between Pudong airport logistics and Pudong economy, and use the gray relational theory to calculate the gray relational degree of Pudong airport logistics and Pudong economy. According to the results of empirical analysis, summarized propose corresponding recommendations and provide effective suggestions for the Pudong government and related enterprises to promote coordinated development of airport logistics and regional economy.

Community fitness circle in China

( Kou Lei ) 대한운동사협회 2017 대한운동사협회 운동사대회자료집 Vol.2017 No.-

Shear mechanism of steel fiber reinforced concrete deep coupling beams

Kou Li,Jun Zhao,Wenbo Ren 국제구조공학회 2020 Structural Engineering and Mechanics, An Int'l Jou Vol.73 No.2

Deep coupling beams are more prone to suffer brittle shear failure. The addition of steel fibers to seismic members such as coupling beams can improve their shear performance and ductility. Based on the test results of steel fiber reinforced concrete(SFRC) coupling beams with span-to-depth ratio between 1.5 and 2.5 under lateral reverse cyclic load, the shear mechanism were analyzed by using strut-and-tie model theory, and the effects of the span-to-depth ratio, compressive strength and volume fraction of steel fiber on shear strengths were also discussed. A simplified calculation method to predict the shear capacity of SFRC deep coupling beams was proposed. The results show that the shear force is mainly transmitted by a strut-and-tie mechanism composed of three types of inclined concrete struts, vertical reinforcement ties and nodes. The influence of span-to-depth ratio on shear capacity is mainly due to the change of inclination angle of main inclined struts. The increasing of concrete compressive strength or volume fraction of steel fiber can improve the shear capacity of SFRC deep coupling beams mainly by enhancing the bearing capacity of compressive struts or tensile strength of the vertical tie. The proposed calculation method is verified using experimental data, and comparative results show that the prediction values agree well with the test ones.

Preparation and Characterization of Paclitaxel-loaded PLGA Nanoparticles Coated with Cationic SM5-1 Single-chain Antibody

Kou, Geng,Gao, Jie,Wang, Hao,Chen, Huaiwen,Li, Bohua,Zhang, Dapeng,Wang, Shuhui,Hou, Sheng,Qian, Weizhu,Dai, Jianxin,Zhong, Yanqiang,Guo, Yajun Korean Society for Biochemistry and Molecular Biol 2007 Journal of biochemistry and molecular biology Vol.40 No.5

The purpose of this study was to develop paclitaxel-loaded poly(lactide-co-glycolide) (PLGA) nanoparticles coated with cationic SM5-1 single-chain antibody (scFv) containing a polylysine (SMFv-polylys). SM5-1 scFv (SMFv) is derived from SM5-1 monoclonal antibody, which binds to a 230 kDa membrane protein specifically expressed on melanoma, hepatocellular carcinoma and breast cancer cells. SMFv-polylys was expressed in Escherichia coli and purified by cation-exchange chromatography. Purified SMFv-polylys was fixed to paclitaxel-loaded PLGA nanoparticles to form paclitaxel-loaded PLGA nanoparticles coated with SMFv-polylys (Ptx-NP-S). Ptx-NP-S was shown to retain the specific antigen-binding affinity of SMFv-polylys to SM5-1 binding protein-positive Ch-hep-3 cells. Finally, the cytotoxicity of Ptx-NP-S was evaluated by a non-radioactive cell proliferation assay. It was demonstrated that Ptx-NP-S had significantly enhanced in vitro cytotoxicity against Ch-hep-3 cells as compared with non-targeted paclitaxel-loaded PLGA nanoparticles. In conclusion, our results suggest that cationic SMFv-polylys has been successfully generated and may be used as targeted ligand for preparing cancer-targeted nanoparticles.

Facile synthesis of nitrogen-doped carbon dots (N-CDs) and N-CDs/NiO composite as an efficient electrocatalyst for oxygen evolution reaction

Kou Xiaoli,Xin Xin,Zhang Yan,Meng Long-Yue 한국탄소학회 2021 Carbon Letters Vol.31 No.4

Nitrogen-doped carbon dots (N-CDs), derived from the biomass (anthocyanin), are the novel additive to the nanocarbon materials, which is expected to bring a wide spectrum of novel applications. Moreover, metallic oxides are emerging for their unique potential for electrocatalysis. Herein, we report the synthesis of N-CDs for the selective detection of Fe3+ with a limit of detection of 2.57 μM in the range of 5–60 μM using ethylenediamine and H2O2 by a hydrothermal method. The obtained N-CDs displayed a spherical morphology with a particle size range of 2–7 nm and emitted blue luminescence at 394 nm under excitation at 319 nm. Meanwhile, we have demonstrated the fabrication of cost-efcient electrocatalysts for oxygen evolution reaction (OER) in an alkaline medium, employing N-CDs. Owing to the successful incorporation of N-CDs into NiO nanospheres, the resulting N-CDs/NiO with large surface areas, fast charge transfer, and increased conductivity vastly improved the catalytic activity. Remarkably, the optimal of N-CDs/NiO composite requires the overpotential of only 380 mV at a current density of 10 mA cm−2 and a relatively low Tafel slope of 57.96 mV dec−1 compared with pure NiO. These results open up a facile route for the application of N-CDs and ofer prospects for CD-metal hybrids as high OER catalysts in electrochemical energy devices.

Representation of Network Security Situation Elements Based on Cloud Model

Kou Guang,Yang Haopu,Wang Kun,Zhang Yuchen,Wang Shuo 보안공학연구지원센터 2016 International Journal of Security and Its Applicat Vol.10 No.5

Aiming at efficiently aware the network security situation, we proposed a framework of Network Security Situation Awareness on the base of Cloud Model. With network security situation elements at the core, we modified the Cloud Model to a novel concept, situation cloud, which act as theoretical foundation in the transition between the qualitative and quantitative representation on situation elements. Finally, the experimental results showed that these two kind of representations can directly summarize the secur