http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
광전 방식에 의한 피하 지방층의 비만도 측정에 관한 연구
오세용,이영우,Oh, Se-Yong,Lee, Young-Woo 한국정보통신학회 2008 한국정보통신학회논문지 Vol.12 No.6
광학적 방식은 백색광 LED광원을, 전기적 방식은 BIA(Bio-electrical Impedance)방식을 이용하여 동시에 측정할 수 있는 광전기적 지방측정에 관한 상관식을 유도하였다. 실험을 통해서 BIA 방식의 경우 5V 및 50kHz의 입력 교류 신호에 대해 6도의 위상차와 2.7V의 전압 강하를 확인하였다. 광학적 방식의 경우 이두박근, 허벅지, 삼두박근의 순으로 광강도가 높아지는 것을 확인하였다. 측정된 광전 방식의 값은 상관식에 의해서 20%의 퍼센트 비만도를 얻었다. Body fat correlation formula induced by using optical method was used white light LED source and electrical method used BIA(Bio-electrical Impedance Analysis) method measured at same time. In the case of BIA method confirmed phase difference of 6 degree and voltage drop of 2.7V at 5V and 50kHz's input signal. In the case of optical method confirmed that optical intensity increased by order of the biceps, the fleshy inside of the thigh and the triceps. We obtained percent body fat of 20% with the body fat correlation formula induced by photo-electricity method.
여러 가지 도판트에 의해 도핑된 전도성 폴리아닐린 LB 박막의 제조 및 전기적 성질
오세용,오병근,최정우,김형수,이희우,이원홍 ( Se Young Oh,Byung Keun Oh,Jeong Woo Choi,Hyung Su Kim,Hee Woo Rhee,Won Hong Lee ) 한국공업화학회 1997 공업화학 Vol.8 No.2
N/A Polyaniline(PANI)-stearic acid(SA) composite monolayer was formed at the air-water interface. The stearic acid as a surfactant was used to promote PANI monolayer formation. Uniform PANI-SA monolayer assemblies with Y type and transfer ratio of ca. 1 were fabricated using the Langmuir-Blodgett(LB) technique. The PANI-SA composite LB films with high electrical conductivity of 10^(-1)∼10^(-2)S/cm were obtained by doping of HCl or I_2, and their conductivity revealed essentially close value as that of conventional PANI-HCl complex. Especially, iodine is found to be the most promising dopant, since it gives a remarkable stability for the application as a polymer electrode in the MIM molecular device consisted of acceptor, sensitizes, and donor. The structure and physical properties of PANI-SA LB films were investigated through the near-ir UV, FT-IR, and Cyclic voltammetry.
전기전도성 Polyaniline - Polystyrene 복합체의 제조와 성질에 관한 연구
오세용,고형철 ( Se Young OH,Hyung Chul Koh ) 한국공업화학회 1995 공업화학 Vol.6 No.6
아닐린 중합시 용액블렌딩에 의해 전기전도성 polyaniline-polystyrene(PANI-PS) 복합체를 얻을 수 있었다. 아닐린 중합은 도판트인 dodecylbenzenesulfonic acid(DBSA)의 xylene 용액에 녹아 있는 산화제를 아닐린과 PS의 xylene 용액에 첨가하여 행하였다. PANI-PS 복합체의 전기전도도는 PANI의 함유량이 증가 할수록 증가 하였고, 12wt.%의 낮은 함유량에서 0.1S/㎝의 높은 값에 도달할 수 있었다. PANI-PS 복합체에서 PANI의 함유량은 원소분석과 중량 측정에 의해 계산하였다. PANI-PS 복합체는 chloroform, xylene, NMP와 같은 유기용매에 매우 잘 용해되었다. DBSA로 도핑된 순수한 PANI을 180℃에서 3시간 동안 열처리한 후 그 전기전도도는 HCl로 도핑된 PANI의 전기전도도보다 훨씬 더 안정하였다. 주사전자현미경과 FT-IR 측정을 통하여 PANI-PS 복합체의 구조와 형태를 조사하였다. Electrically conductive polyaniline-polystyrene(PANI-PS) composites could be obtained by the solution blending in situ polymerization of aniline. The polymerization was carried out by adding the oxidant solution dissolved dodecylbenzenesulfonic acid(DBSA) in xylene to the xylene solution contained aniline and PS. The electrical conductivity of PANT-PS composites increased with increasing the content of PANI and could reach value as high as 0.1S/㎝ with a low content of 12wt.%. The PANI contents in PANI-PS composites were calculated by means of elemental analysis and weight measurements. The PANT-PS composites were very soluble in organic solvents such as chloroform, xylene and NMP. The electrical conductivity, after the PANI doped with DBSA was thermally treated at 180℃ for 3hrs, was more stable than that of PANT doped with HCl. The structure and morphology of the PANT-PS composites were investigated through the measurements of Scanning Electron Micrograph(SEM) and FT-IR.