http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
신희상(Hee-Sang Shin),조성민(Sung-Min Cho),강철(Chul Kang),김재철(Jae-Chul Kim),강동식(Dong-Sik Kang),조국희(Kook-Hee Cho) 한국조명·전기설비학회 2007 한국조명·전기설비학회 학술대회논문집 Vol.2007 No.11월
This study examines the characteristics of noise occerred at a hydroelectric power plant by using the on-line partial discharge measured by eletrical detecting method under the high voltage rotating machines. In addition, it analyzes the noise pattern into frequency and its scale component by using the FTT technique.
고압 회전기 고정자 권선의 부분방전 계측 시 주변 신호 관계를 고려한 노이즈 제거기법
신희상(Hee-Sang Shin),조성민(Sung-Min Cho),강철(Chul Kang),강동식(Dong-Sik Kang),조국희(Kuk-Hee Cho),김재출(Jae-Chul Kim) 한국조명·전기설비학회 2008 조명·전기설비학회논문지 Vol.22 No.9
최근에 신뢰성 있는 전력공급의 중요성이 증가하고 있다. 이에 따라 전력기기 진단의 중요성 역시 증가하고 있다. 산업설비로 많이 사용되는 고압 회전기는 장기간 사용함에 따라 고정자 권선 절연부분이 열화되어 예상치 못한 절연파괴 사고로 많은 손실을 일으킨다. 이를 진단하기 위하여 고압 회전기 고정자 권선에 접촉식 Capacitive Coupler를 설치하고 부분방전 신호를 계측하여 유지 보수하는 것이 가장 넓게 사용되고 있다. 하지만 현장에서 부분방전 계측 시 노이즈가 혼재된다면 정밀한 부분방전 신호를 계측하는 것이 불가능해진다. 본 논문에서는 국내 수력발전소 중 25년 이상 가동 중인 13[kV]급 수력발전기 고정자 권선에서 160[pF] 용량의 접촉식 Capacitive Coupler를 이용하여 취득한 계측신호를 분석하여 기존 하드웨어적으로만 노이즈를 제거하여도 잔존하는 노이즈를 제거하기 위해 소프트웨어적인 주변신호원과의 관계를 고려한 노이즈제거 기법을 제안하였다. Recently, the importance of supplying the reliable electric power is increasing. therefore, the importance of diagnosis of power equipments is increasing also. Breaking insulation of stator windings is major cause of faults in high voltage generators. On-line PD (Partial Discharge) detection using Capacitive Coupler at stator windings is used widely to diagnose high voltage generators. However, precise PD(Partial Discharge) detection is impossible if detected signals are mixed with PD and noise signal. In this paper, we analyze detected signals using Capacitive Coupler at 13[kV] hydroelectric generator stator winding and suggest not hardware method but noise elimination algorithm for detecting PD of generator stator winding considering relation of periphery signals.
분무 Al-Zn-Mg 합금의 기계적 성질 및 미세조직에 미치는 Ag 첨가의 영향
신희상(Hee Sang Shin),정태호(Tae Ho Jeong),남태운(Tae Woon Nam) 한국주조공학회 1999 한국주조공학회지 Vol.19 No.6
The overall objective of this study is to investigate the effect of Ag addition on the mechanical properties and microstructure of rapid solidified 7000 Al series alloys. Al-Zn-Mg-Cu alloys with small amounts of Ag was fabricated into the powder by gas atomization. The powder was extruded after the cold compaction and degassing and then followed by T6 heat treatment. Microstructure observation, phase analysis, room and high temperature tensile test and hardness test were pursued. The tensile strength and hardness of Ag-added alloy after heat treatment was increased with increasing Ag contents. However, the elongation of extruded alloys was not increased as much as to be expected. The reason of this result seems to be related to theΩ phase, which contribute to the high temperature strength stability of Al-Cu-Zn alloys through the formation of eutectoid with Ag addition. (Received September 13, 1999)
부하 평준화를 위한 변전소 설치 배터리 에너지 저장장치의 모델 및 경제성 평가에 관한 연구
조성민(Sung-Min Cho),신희상(Hee-Sang Shin),김재철(Jae-Chul Kim) 대한전기학회 2012 전기학회논문지 Vol.61 No.7
As development of battery technologies, the installation of Battery Energy Storage System (BESS) increased. The BESS can be used for various purposes such like frequency response, load leveling, and fluctuation mitigation of renewable energy generators. In this paper, three state BESS model is proposed. the BESS model considering charge, discharge and keeping efficiency, and life cycle according to depth of discharge (DOD). Then, the benefit and cost of BESS installed at substation for load leveling are summarized. The economic evaluation of BESS is analyzed using net present values (NPV) analysis. In case study, the NPV analysis of NaS battery system is carried out using the proposed BESS model. Because the result of economic evaluation of BESS using nowadays cost data is not positive, the sensitivity analysis of BESS is conducted by changing the capital cost and energy cost.
조성민(Sung-Min Cho),신희상(Hee-Sang Shin),김재철(Jae-Chul Kim),권동진(Dong-Jin Kweon) 대한전기학회 2007 대한전기학회 학술대회 논문집 Vol.2007 No.4
The DGA (Dissolved Gases Analysis) technique has been widely using for fault diagnosis of the power transformers. This technique has a high reliability than other techniques. KEPCO (Korea Electric Power Cooperation) has been using DGA technique since KEPCO established the criteria of DGA in 1985. In this paper, we introduce the DGA criteria of KEPCO and analyze the result of DGA. Also we introduce the cases of thoroughgoing inspection of the power transformers caused by DGA and compare the judgment of DGA with the result of thoroughgoing inspection.
통계적 퍼지 함수를 이용한 전력용 변압기 유중가스 판정 시스템
조성민(Sung-Min Cho),김재철(Jae-Chul Kim),신희상(Hee-Sang Shin),권동진(Dong-Jin Kweon),구교선(Kyo-Sun Koo) 한국조명·전기설비학회 2007 한국조명·전기설비학회 학술대회논문집 Vol.2007 No.11월
Dissolved gases analysis (DGA) is one of the most useful techniques to detect incipient faults in power transformers. Criteria interpreting DGA result is the most important. Because of difference of operation environment, construction type, oil volume, and etc, the interpretative criteria of DGA at KEPCO must be different with other standard like IEC-60599, Rogers and Doernenburg. In this paper, we collected the DGA data of the normal condition transformers and the incipient fault transformer to suggest the most appropriate criteria. Using these data, this paper suggests appropriate condition classification algorithm. Suggested algorithm can help to detect incipient fault earlier without unnecessary sampling.
계통 고조파와 분산형 전원의 상호작용 평가를 위한 고조파 모델에 관한 연구
조성민(Sung-Min Cho),신희상(Hee-Sang Shin),문원식(Won-Sik Moon),김재철(Jae-Chul Kim) 대한전기학회 2011 전기학회논문지 Vol.60 No.4
As increase of nonlinear loads and renewable energy generators (REGs) being connected to power distribution system via inverters, the concern on harmonic problems have increased. Recently, the harmonics evaluation method considering TDD (Total Demand Distortion) is used to analyze the effect of harmonics from inverters on power distribution quality. Harmonic current sources are typically used for simulation of nonlinear load. Most inverter type for REGs is voltage source inverter (VSI). So, harmonic voltage sources are more suitable to analyze impact of renewable energy generator on harmonics problem in power distribution system. In this paper, we presented the circuit model to analyze interaction between harmonics from nonlinear load and REGs. We verified that the harmonic analysis using the proposed circuit model is more appropriate than the harmonics evaluation method considering TDD through case study using PSCAD/EMTDC.
스마트계량시스템을 활용한 수요관리자원에 대한 가치평가연구
임상국(Sang-Kug Lim),신희상(Hee-Sang Shin),조성민(Sung-Min Cho),이희태(Hee-Tae Lee),윤용태(Yong-Tae Yoon),김재철(Jae-Chul Kim) 한국조명·전기설비학회 2010 조명·전기설비학회논문지 Vol.24 No.2
에너지관련 자원가격의 급등으로 전력생산비용이 증가하여 세계 여러 나라의 전력회사들이 재정적인 어려움에 직면하고 있다. 이러한 전력 생산비용과 판매가격의 왜곡을 해결하기 위한 다양한 방법이 모색되고 있다. 본 논문에서는 제안된 스마트계량시스템은 전력 소비자의 전력사용 정보제공을 통한 소비패턴을 변화시켜 전력에너지절감을 유도하는 효과가 있는 것으로 알려져 있다. 우리나라에서는 스마트계량시스템의 보급을 위해 2008년도 실효성 검증을 위한 실증연구 과제를 추진하였으며, 본 논문에서는 그 결과를 바탕으로 스마트계량시스템 보급에 따른 잠재적 이득과 캘리포니아 테스트를 통한 가치평가 결과를 제시하였다. Recently, the crude oil price per one barrel in 2005 cost 49.4 dollars. But the value of crude oil in 2007 had ascended 68.4 dollars which was skyrocketed 38.5[%] owing to the sudden rise of energy price. As it has been growing the necessity of energy efficiency, energy intentive companies actively try to implement energy management system. It has been studied to improve the energy saving for household sector using the smart metering system which can give the information of energy prices, pattern on real time to energy consumers and voluntarily lead the activities of energy saving. In this paper, we estimated potential benefits and value of smart metering system through california test.
AE(Acoustic Emission)센서를 이용한 오차에 강인한 부분방전 위치추정 알고리즘에 관한 연구
조성민(Sung-Min Cho),신희상(Hee-Sang Shin),김재철(Jae-Chul Kim),이양진(Yang-Jin Lee),김광화(Kwang-Hwa Kim) 한국조명·전기설비학회 2008 조명·전기설비학회논문지 Vol.22 No.10
본 논문에서는 오차에 강인하게 초음파센서를 이용한 부분방전 위치를 추정하는 알고리즘을 제시하였다. 변압기 내부는 유온이 균일하지 않기 때문에 초음파의 절연유에서 전달 속도를 정확하게 산정하기 힘들다. 그렇기 때문에 처리 과정에서 일정 오차가 발생하게 된다. 따라서 점검자에게 유용한 정보를 제공하기 위해 부분방전의 위치추정 알고리즘은 이런 오차를 충분히 반영하여야 한다. 기존의 위치추정 기법은 좌표로 부분방전 발생 위치를 나타내었지만 본 논문에서 제시하는 LookUp-Table(LUT)를 이용한 기법은 부분방전 발생 위치를 지도형태로 나타내도록 하여 점검자에게 충분히 유용한 정보를 제공할 수 있도록 하였다. 또한 임의로 데이터에 오차를 일으켜 기존 기법과 제시한 기법의 성능을 비교하였다. This paper presents an algorithm robust to error for estimating partial discharge (PD) location using acoustic emission sensors. In operating transformers, the velocity computing of the acoustic signal is difficult because the temperature of the insulation oil is not homogeneous. So, some error occurs in the process. Therefore, the algorithm estimating PD location must consider this error to provide maintenance person with useful information. The conventional algorithm shows the PD position as a point, while the new algorithm using LookUp-Table(LUT) shows PD position as error-map visually. The error-map is more useful than the conventional result because of robustness to error. Also, we compared performance of them, by adding error to data on purpose.