http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
알루미늄 캔재의 이어링률 측정을 위한 비젼 시스템 구현
이양범,신신범,Lee Yang-Bum,Shin Seen-Beom 한국융합신호처리학회 2005 융합신호처리학회 논문지 (JISPS) Vol.6 No.1
The implementation of vision system using CCD camera which measures the earing rate of aluminium CAN is represented in this paper. In order to optimize the input image, the object of the input image is separated and the position of the image is calibrated. In the preprocessing, the definition of image is improved by the histogram equalization, and then the edges of the input image are detected by the Robert mask. The heights of the four ears and angles of the aluminium CAN are measured manually with the digital vernier calipers in industry. It takes 30 seconds to measure manually the height of one direction of the aluminium CAN at least three times. However, when the proposed system in this paper is applied, it takes 0.02 seconds only. In conclusion, the efficiency of the proposed system is higher than that of the system used in the industry. 본 연구는 압연된 알루미늄 원판으로부터 추출된 캔재를 CCD 카메라를 이용하여 이어링률을 측정하는 시스템 개발이 주 목적이다. 입력받은 영상을 최적화하기 위하여 영상의 객체 분리 및 위치 보정을 해주었고, 전처리 단계로서 히스토그램 평활화에 의한 선명도를 개선시켜 준 다음 로버트 마스크를 이용하여 에지를 검출하였다. 현장에서는 알루미늄 특성상 발생된 캔재의 각 4개의 귀와 골의 높이를 디지털 버니어 캘리퍼스를 이용하여 수작업으로 측정하는데 처리 속도면에서 알루미늄 캔재의 1방향의 높이당 최소 3번 측정에 의하여 30초가 소요되었다. 반면에 스텝모터를 이용하여 캔재를 45°씩 회전시키면서 각각의 귀와 골의 높이 측정을 본 시스템을 적용하였을 때 0.02초의 시간이 소요되었다. 따라서 본 시스템을 이용한 결과 산업 현장에서 제품 처리 결과와 비교, 만족할 만한 성능이 입증되었다.
이은웅(Eun Ung Lee),이양범(Yang Bum Lee) 대한공업교육학회 1980 대한공업교육학회지 Vol.5 No.1
In this study, a numerical method in the descretized version of the system dynamics is presented by the use of the digital computer. Several alternative methods on the similar subject have been presented already by many authers but most of them pursued the problem in the classical approaches in the complex frequency domain analysis and it reveals certain difficulties in obtaining the analytical results, provided the order of the treating system is high. and so, this recursive nture of the numerical method has shown incompatible merit to the classical method in getting the desired satisfactory solution; in more simple, accurate and rapid way. These models become basis of solving practical dynamic characteristics when the D. C motor is used as an actuator.