http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
전원의 고조파 제거를 위한 Hybrid Filter의 실현
방선배(Sun-Bae Bang),정동열(Dong-Youl Jung),황환영(Hwan-Young Hwang),박종연(Chong-Yeun Park) 전력전자학회 2004 전력전자학술대회 논문집 Vol.- No.-
This paper proposed Hybrid Filter for harmonics elimilation on the power line. It's control method is very simple, but its permance is better than the results by passive filter. For the harmonics elimination, we improved the performance of the BPF(Band-pass Filter) with the GIC(Generalize Impedance Converter), and the new hysterisys controller.
方善培(Sun-Bae Bang),朴鍾演(Chong-Yeun Park) 대한전기학회 2008 전기학회논문지 Vol.57 No.3
This paper presents the analyzed result of the series arc fault current by using the discrete wavelet transform. The series arcing is caused by a loose connection in series with the load circuit. The series arc current is limited to a moderate value by the resistance of the device connected to the circuit, such as an appliance or a lighting system. The amount of energy in the sparks from the series arcing is less than in the case of parallel arcing but only a few amps are enough to be a fire hazard. Therefore, it is hard to detect the distinctive difference between a normal current and a intermittent arc current. This paper, presents the variation of the ratio of peak values and RMS values of the series arc fault current, and proposes the novel series arc fault detecting method by using the discrete wavelet transform. Loads such as a CFL lamp, a vacuum cleaner, a personal computer, and a television, which has the very similar normal current with the arc current, were selected to confirm the novel method.
HID램프와 안정기 사이의 전선 길이에 따른 이그니션 전압 전달특성 분석
方善培(Sun-Bae Bang),金鍾旻(Chong-Min Kim),韓雲基(Woon-Ki Han),林秉魯(임병노),張牧淳(Mog-Soon Jang) 대한전기학회 2007 전기학회논문지 P Vol.56 No.3
In this paper, characteristics of ignition voltage and current by wire length of HID(High Intensity Discharge) lamp circuit are analyzed. In the construction field, decision of the wire thickness for HID lamp circuit has the problems, and these are presented. Through transmit parameters, equivalent model of the ballast and HID lamp circuit was derived. The graph of voltage reduction about length between the ballast and the lamp is shown. The simulation of proposed model and experimental results are presented in order to validate the proposed method. The proposed model and graph can use to choose the proper length of wire between the ballast and the lamp in the field.
아크차단기(AFCI) 시험용 탄화경로아크시험장치 개발 및 신호분석
방선배(Sun-Bae Bang),김종민(Chong-Min Kim),김기남(Ki-Nam Kim),최왕섭(Wang-Seop Choi),박종연(Jong-Yeon Park) 대한전기학회 2009 대한전기학회 학술대회 논문집 Vol.2009 No.10
본 논문에서는 개발된 아크차단기(AFCI)의 성능을 시험하기 위한 탄화정로 아크시험 장치를 UL 1699 규격에 따라 개발하고 발생된 신호를 분석하였다. 단화경로 아크시험 장치 는 아크점화시험(arc ignition test), 아크차단시험(arc interruption test), 아크제거시험(arc clearing time test)으로 나눌 수 있으며, 본 연구에서는 제시한 3가지 시험을 효과적으로 수행할 수 있도록 하나의 장치로 개발하였다. 또한 아크점화시험, 아크차단시험, 아크제거시험에서 발생된 신호를 측정하고 분석하여 각 장치에 대한 시험방법을 쉽게 이해할 수 있도록 하였다.
아크차단기(AFCI) 오동작 방지를 위한 시험부하 선정 및 전압 · 전류 분석
방선배(Sun-Bae Bang),송길목(Kil-Mok Shong),김종민(Chong-Min Kim),김영석(Young-Seok Kim),최명일(Myeong-il Choi) 대한전기학회 2010 대한전기학회 학술대회 논문집 Vol.2010 No.11
본 논문에서는 아크차단기(AFCI) 오동작 방지를 위한 시험 부하 및 시험방법을 제시하고 오동작 시험부하의 전압 · 전류를 측정 분석하였다. 아크차단기 시험에는 아크고장 검출시험과 오동작시험으로 나눌 수 있다. 아크차단기의 아크고장 검출 기술은 많은 연구에 의하여 매우 향상되었다고 할 수 있으나 오동작을 방지를 위한 기술은 매우 미흡하다고 할 수 있다. 아크차단기의 아크고장 검출 성능과 오동작 방지 성능은 상호 불가분의 관계를 갖고 있다. 아크고장 검출 성능을 향상시키면 오동작 발생 확률이 높아지게 된다. 따라서 아크차단기의 성능을 향상시키기 위해서는 아크고장 검출 성능과 오동작 방지 성능을 상호 고려하여야 한다. 본 논문에서는 UL 규격에서 제시하는 아크차단기 오동작 방지를 위한 시험부하 및 방법을 분석하여 국내 전기환경에 적합한 오동작 시험부하 선정 및 방법을 제시하고 오동작 시험부하의 정상진압 · 전류, 아크고장 전압 · 전류를 측정 분석하였다.
이산 웨이블렛 변환을 이용한 직렬 아크고장 신호 검출 방법 분석
방선배(Sun-Bae Bang),김종민(Chong-Min Kim),박종연(Chong-Yeun Park),정영식(Young-Sik Chung) 대한전기학회 2009 전기학회논문지 P Vol.58 No.3
Electrical fires have been occurred continuously in spite of installing ELB. Therefore the concern with the electrical arc-fault that cause the fire has growing. This paper measured series arc fault currents by the method of arc generator test in UL standard 1699. The used analysis methods in this paper are three different ways using DWT(discrete wavelet transform) those are frequently used for the arc fault current signal analysis. The arc fault detection probability is 100 % by method using noise-energy/shoulder-duration ratio of approximation coefficient. As these results, the variation of noise-energy and shoulder-duration ratio of approximation coefficient are founded important factors for the analysis of arc fault.
방선배(Sun-Bae Bang),김종민(Chong-Min Kim),한운기(Woon-Ki Han),임병노(Byoung-Noh Lim) 대한전기학회 2007 대한전기학회 학술대회 논문집 Vol.2007 No.4
본 논문은 메탈헬라이드 램프들의 이그니션 특성 비교 분석을 위하여 이그니션 구간에서의 전압, 전류 및 순시임피던스(time varying resist ance), 순시전력(time varying power)을 측정하고 분석하였고, 측정 및 분석을 위하여 램프의 종류(B형, BT형)와 제조회사가 다른 램프 6종을 선택하여 사용하였다. 분석결과, 제조회사별, 램프 상태 등에 따라 이그니션 특성이 매우 상이하게 나타났으며, 대부분의 램프 이그니션 전류가 40[A]를 상회하고 있고, 특히 몇몇 램프의 이그니션 전류는 50[A] 이상으로 나타났다. 따라서 메탈헬라이드 램프들의 이그니션 전류는 정상상태보다 큰 이그니션 전류 및 순시전력이 발생되고 있음을 알 수 있었다. 따라서 본 연구 결과는 전자식 안정기 설계 시, 특정 램프 뿐만 아니라 여러 램프의 이그니션 전류를 만족하는 설계가 필요하며, 메탈헬라이드 램프 시공 시, 램프의 이그니션 구간에서 발생하는 l~2[㎸] 고전압 및 50[A] 이상의 대전류에 따른 적절한 안전사고 대책 및 관동회로의 절연, 전선 굵기 선정이 필요한 것으로 나타났다.
웨이블렛 변환을 이용한 비선형 부하 전원선에서의 직렬 아크고장 신호 분석
方善培(Sun-Bae Bang),朴鍾演(Chong-Yeun Park),張牧淳(Mog-Soon Jang),崔原豪(Won-Ho Choi) 대한전기학회 2008 전기학회논문지 Vol.57 No.8
In this paper, a new detection method of series arc-fault signals occurring at the wiring of home appliances is proposed. The discrete wavelet transform was used for the numerical analysis of the variation rate in peak, RMS, noise energy, shoulder of the arc-fault current wave. As a results, the arc distinction threshold value of these variation rates was about 0.1 in most cases. The arc-fault current of the loads with the active PFC circuit showed a high rate of variation in noise energy and shoulder, but arc-fault current of the loads without the active PFC circuit showed a high rate of variation in peak and RMS. The arc fault current in resistive loads showed a high rate of variation in shoulder.
방선배(Sun-Bae Bang),김종민(Chong-Min Kim),박종연(Chong-Yeun Park) 대한전기학회 2009 대한전기학회 학술대회 논문집 Vol.2009 No.4
누전차단기 설치 상태에서도 전기화재가 지속적으로 발생함에 따라 전기화재의 원인이 되는 전기 아크에 대한 관심이 중가하고 있는 실정으로, 본 논문에서는 UL1699의 아크 저해 시험(inhibition tests)에서 제시하고 있는 직렬 아크고장시험(Arc generator test)을 실시하고, 아크고장전류 분석방법으로 최근에 많이 사용되고 있는 이산 웨이블렛 변환을 이용한 3가지 분석방법에 대하여 아크고장전류 검출 확률을 분석하였다. 분석결과, ① 근사계수 분석에 의한 최대치 변화율 · 실효치 변화율 분석방법은 46%의 검출 확률을 얻을 수 있었고, ② 상세계수 분석에 의한 최대치 변화율 · 실효치 변화율 분석방법은 62%, ③ 근사계수 분석에 의한 잡음량 변화율 · shoulder 변화율 분석방법은 100% 검출 확률을 얻을 수 있었다.