http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
AAPM TG18에 의한 진단용 CRT 디스플레이 시스템의 성능 평가
김희중,정해조,민덕기,홍진오,김용년,Kim, H.J.,Jung, H.J.,Min, D.K.,Hong, J.O.,Kim, Y.N. 대한디지털의료영상학회 2003 대한디지털영상기술학회지 Vol.6 No.1
디지털 영상 검출기와 디스플레이 기술의 발달과 의료영상전달시스템(PACS)의 출현은 전통적 필름방식에 비하여 디지털 방식으로 방사선과 영상을 획득하고 전송, 저장하는 매우 효과적인 수단을 제공하고 있다. 2002년 8월, 연세의료원 세브란스병원은 진단 영상 판독 목적으로 18 대의 CRT(Braco View, Belgium)와 32대의 평판 LCD(Totoku Electric Co., Ltd., Japan) 디스플레이 장치를 GE full-PACS(GE 메디칼시스템코리아 : GEMSK)와 연계하여 설치 완료하였다. 본 연구에서, 기하학적 왜곡, 반사, 휘도 반응, 휘도 균일도, 분해능, 노이즈,베일링 글레어, 칼라 균일도 항목들을 AAPM TG18 보고서 9.0에 따라서 시각적 그리고 부분적으로는 정량적인 방법으로 인수검사를 실시하여 보고한다. 사용된 장비는 색도계로도 사용되는 간편한 휘도계, TG18 테스트 패던, AAPM Tg18 AT plug-in software(Barco View Ltd., Kortrijk, Belgium)이었다. 칼라 균일도를 제외한 모든 테스트 결과는 AAPM TG18에서 권고하는 기준에 일치하였으며 진단 영상 판독에 사용하기에 전적으로 수락할 수 있는 성능이었다. 결론으로, 사용된 인수검사는 단지 인수 검사 표준을 제공하는 것 뿐만 아니라 품질검사(QC)의 지침, 판독 환경의 최적화 그리고 교체 시기나 업그레이드 시기를 결정하여주는 중요한 역할을 할 수 있을 것이다.
직렬주입변압기가 없는 새로운 UPQC(Unified Power Quality Conditioner)의 성능분석
김희중(H.J.Kim),배병열(B.Y.Bae),전영수(Y.S.Jon),한병문(B.M Han),김현우(H.W.Kim) 전력전자학회 2003 전력전자학술대회 논문집 Vol.2003 No.7(1)
This paper proposes a novel UPQC( unified power quality conditioner) based on H-bridge modules, isolated through single-phase multi-winding transformers The dynamic performance of proposed system was analyzed by simulation with EMTDC/PSCAD, assuming that the UPQC is connected with the 229kV distribution line The proposed system can be directly connected to the transmission line without series Injection transformers It has flexibility in expanding the operation voltage by Increasing the number of H-bridge modules and can compensate reactive power, harmonics, voltage sag and swell, voltage unbalance The control strategy for the proposing UPQC was derived Using the Instantaneous power method<br/> The proposing UPQC has the ultimate capability of improving power quality at the point of Installation on power distribution systems or Industrial power systems and can be utilized for the future distribution system
이용호(Y.H.Lee),이연숙(Y.S.Lee),신용돌(Y.D.Shin),문기원(K.W.Moon),노태환(T.H.Noh),김희중(H.J.Kim),강일구(I.K.Kang) 한국자기학회 1991 韓國磁氣學會誌 Vol.1 No.1
A measurement system for magnetic anisotropy was built. The torque acting on the disc or sperical samples placed in uniform magnetic field was detected with a capacitive transducer which is connected with a transformer ratio-arm bridge. The output of the bridge was amplified with a lock-in amplifier. The cubic anisotropy constant for (100) of 3% Si-Fe was 3.3×10⁴ J/㎥. The calibration for the system was carried out with the shape anisotropy of a thin Ni wire.
비정질 Sm - Fe계 합금 박막의 유도자기이방성 형성
송상훈(S. H. Song),이덕열(D. Lee),한석희(S. H. Han),김희중(H. J. Kim),임상호(S. H. Lim) 한국자기학회 1998 韓國磁氣學會誌 Vol.8 No.5
Induced anisotropy with the energy of 6×10⁴ J/㎥ is obtained in amorphous Sm-Fe based thin films which are fabricated by rf magnetron sputtering under a magnetic field of 500~600 Oe. Compared with conventional thin films, the anisotropic thin films exhibit a similar saturation magnetostriction, but show a very large anisotropy in magnetostriction which is of significant practical importance due to increased strain at a particular direction. It is shown from a systematic investigation over a wide composition range for binary Sm-Fe alloys that anisotropy is also induced, though small, during a normal sputtering procedure due to the stray field, and the largest anisotropy is observed in the composition range of 25~30 at.% Sm. Furthermore, induced anisotropy is also found to be formed by magnetic annealing, but the anisotropy energy is much smaller than that by magnetic sputtering. This may be because the volume diffusion by which atoms move during magnetic annealing to form induced anisotropy is much slower than the surface diffusion which is expected to be a dominant factor during magnetic sputtering.