http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
한병성,Han, Byoung-Sung 대한전자공학회 1989 전자공학회논문지 Vol.26 No.3
비유전율 및 팽창계수가 낮다는 장점을 갖고 있는 코디에리트는 IC페키지로서 매우 흥미있는 재료이다. 졸겔방법에 의해서 얻어진 코디에리트는 무정형 하얀 가루의 결정으로 이를 약 $900^{circ}C$ 로 열처리 하여, 구운 코디에리트 시료를 만들었다. XPS에 의해서, 코디에리트 시료의 미시적 특성을 연구하였는데, 시료 표면에서는 시료내부의 값들과 비교해 볼때, Mg의 많은 감소와 AI과 Si의 증가를 알 수 있었다. $100{\AA}$ 이하의 시료표면에는 ${pi}$ - 코딩리트 상을 갖는 결정이 존재하고, 시료내부는 적은량의 마그네슘 알루미나트($MgAl_2O_4$)가 존재하였다. 한편 코디에리트 표면에서 열처리에 다른 화학적 변화가 없는 것을 알 수 있었다. The cordierite is of great interest for microelectronic packaging. Its main advantages are low dielectric constant and low thermal expansion. The cordierite precursor obtained by sol-gel synthesis whose sintering temperature is about $900^{circ}C$ is an amorphous and cristal white powder. Green and fired cordierite samples were studied by XPS for microscopic properties. At the surface the results of XPS show forte diminution of Mg in comparison with its value at volume and the deficit of Mg compensates by augmentation of Al and Si. $pi$-cordierite phase is present near the surface $<100{\AA}$ and small quantities of magnesium aluminate ($MgAl_2O_4) is present in the bulk. Sintering of the green cordierite introduces no chemical modification at the surface.
3차 권선에 저항을 사용한 변압기형 전류제한기의 동작 특성
최병환,한병성,Choi, Byoung-Hwan,Han, Byoung-Sung 한국전기전자재료학회 2008 전기전자재료학회논문지 Vol.21 No.12
A transformer type superconducting fault current limiter (SFCL) is one of the fault current limiters which have been proposed to reduce the fault current in the transmission lines. This paper proposes the new circuit configuration of a transformer type SFCL and also investigates the operating characteristics of the transformer type SFCL containig the resistor in the tertiary winding. The proposed SFCL contains the resistor in the tertiary winding. The newly inserted resistor can divert the power which the High-Tc superconducting has to bear. Because the resistor in the tertiary winding relieves the power of the High-Tc superconducting, it is possible that the proposed transformer type SFCL can decrease the more larger fault current than the conventional SFCL with the same High-Tc superconducting. And the cost of the proposed transformer type SFCL can be reduced.
개구결합을 이용한 H 형태 초전도 안테나의 제작 및 특성 해석
정동철,한병성,유기수,이종하,석중현,이은홍,Chung, Dong-Chul,Han, Byoung-Sung,Ryu, Ki-Su,Lee, Jong-Ha,Sok, Jung-Hyun,Lee, Eun-Hong 대한전자공학회 2000 電子工學會論文誌 IE (Industry electronics) Vol.37 No.1
"H" 형태의 공진기로서 이루어진 초전도 안테나는 비슷한 크기를 가진 마이크로스트립 안테나에 비하여 소형화에 유리하다. "H"형 초전도 안테나 제작을 위해 rf 마그네트론 스퍼터링을 이용하여 $YBa_2Cu_3O_{7-x}$ (YBCO)/MgO 고온초전도 박막을 제조하였으며 표준 식각법을 이용하여 안테나를 형상화 하였다. 일반 금속과의 특성을 비교하기 위해서 동일한 차원의 금 안테나가 제작되었다. 개구 결합 방식을 이용하여 초전도 안테나 패치와 $50{\Omega}$ 급전선을 임피던스 결합을 시켰다. 다양한 종류의 실험 결과가 반사손실, 공진주파수, 특성임피던스 등을 중심으로 보고되었다. H형 초전도 안테나는 금 안테나에 비하여 정재파비에서 0.36 효율에서 24% 반사손실에서 14.6bB 이상 더 우수한 성능을 보여주었다. The high-$T_c$ Superconducting (HTS) antenna which consists of "H" type resonator has the benefits for the miniaturization of antenna in comparison with the microstrip antenna of the similar dimension. To fabricate the "H" type antenna, HTS $YBa_2Cu_3O_{7-x}$ (YBCO) thin films were deposited on MgO substrates using rf-magnetron sputtering. Standard etching processes were performed for the patterning of the "H" type antenna. For comparison between normal conducting antennas and superconducting antennas, the gold antennas with the same dimension were also fabricated. An aperture coupling was used for impedance matching between $50{\Omega}$ feed line and HTS radiating patch. The diverse experimental results were reported in terms of the resonant frequency, the return loss and the characteristics impedance. The "H" type superconducting antenna showed the performance of 1.36 in SWR, 24% in efficiency, and 14.6 dB in the return loss superior of the normal conducting counterpart.
임성훈(Sung-Hun Lim),주연홍(Yeon-Hong Joo),이성룡(Seong-Ryong Lee),한병성(Byoung-Sung Han) 전력전자학회 2001 전력전자학술대회 논문집 Vol.2001 No.7
This paper suggests the circuit topology to transfer AC power using a detachable transformer. The circuit topology for AC output load through the magnetic coupling and its principle of operation are described. It can decrease the size of detachable transformer by employing the high-frequency magnetic coupling. It is shown in this paper that the efficiency of noncontact energy transfer system can be improved by applying both the full bridge converter with PFC function to the 1st side of its and the series resonance to the 2nd side to minimize the effect of the leakage inductance.
삼상 분리 및 일체화된 자속구속형 초전도 사고전류제한기의 동작특성
임성훈(Sung-Hun Lim),조용선(Yong-Sun Cho),박형민(Hyoung-Min Park),박충렬(Chung-Ryul Park),한태희(Tae-Hee Han),두호익(Ho-Ik Do),송재주(Jae-Joo Song),최효상(Hyo-Sang Choi),한병성(Byoung-Sung Han) 대한전기학회 2006 대한전기학회 학술대회 논문집 Vol.2006 No.7
하나의 철심을 매개로 각 상의 1, 2차 권선이 동일한 권선비로 결선된 삼상 일체화된 자속구속형 초전도 사고전류제한기의 동작특성을 모델링하였다. 삼상 일체화된 자속구속형 사고전류제한기는 평상시에 각 상의 두 코일에서 유기되는 자속이 서로 상쇄되어 철심내부의 자속은 발생하지 않게 된지만 임의의 한 상에서 단락사고가 발생할 경우 삼상이 분리된 사고전류제한기와 달리 사고상 뿐 아니라 건전상에 연결된 초전도소자도 ?지가 발생하는 특징이 있다. 등가회로를 이용한 모델링을 통해 삼상이 분리된 경우와 삼상이 일체화된 경우의 동작특성을 비교분석하였다.
직접삽입 급전 방식을 이용한 고온초전도 마이크로스트립 안테나의 제작 및 특성 해석
정동철,한병성,김진,유기수,홍석용,이종하,Chung, Dong-Chul,Han, Byoung-Sung,Kim, Jin,Ryu, Ki-Su,Hong, Suck-Yong,Lee, Jong-Ha 대한전자공학회 2000 電子工學會論文誌 IE (Industry electronics) Vol.37 No.1
초전도체를 초고주파 소자에 응용하려고 할 경우, 초전도 전자기학의 불확실함이나 초전도 기판의 돈도 의존성은 산업 응용을 위한 안테나를 제작하는데 있어 어려움을 준다. 따라서 실제 응용을 위해서는 일반 안테나와 비교하여 정확하고 자세한 특성이 알려져야만 한다. 본 논문에서는 금 안테나와 초전도 안테나의 비교 연구를 수행하였으며 반사 손실, 특성임피던스, 효율 및 다른 다양한 특성들을 보고하였다. 본 연구에 사용된 고온초전도 박막은 $YBa_2Cu_3O_{7-x}$ (YBCO)/MgO 이며 초전도 안테나는 마이크로스트립 급전선을 방사 패치의 50 ${\Omega}$ 영역에 결합시키는 형태로 만들어졌다. 금 안테나와 초전도 안테나의 측정 결과는 이러한 구조를 이용하여 유용한 안테나가 제작될 수 있음을 보여주었다. In applying high-${\underline{T_c}}$ superconducting material to microwave devices, Uncertainty of electromagnetics of high-${\underline{T_c}}$ superconductor(HTS) and the temperature dependence of the substrate fits with HTS thin film cause difficulty in realization of such antenna for industrial applications. It must be noted to characteristic the HTS antenna in contrast with normal conducting counterpart for this real application. In this paper, a comparative study between HTS microstrip antennas and gold antennas was reported in terms of the return loss, the characteristic impedance, efficiency, and other various characteristics. HTS thin films were $YBa_2Cu_3O_{7-x}$ (YBCO) on MgO substrates. Superconducting microstrip antennas used in this work were to directly inset a microstrip transmission line into the 50 ${\Omega}$ region of the radiating patch. Measurement results of HTS antennas and gold antennas showed that usable antennas can be made using this architecture.