벡터라이징을 이용한 자동부재배치 소프트웨어 개발에 관한 연구 = A Study on Development of Automatic Nesting Software by Vectorizing Technique

다국어 초록 (Multilingual Abstract)

Among processes to manufacture parts from footwear materials like upper leathers, one of the most essential processes is the cutting one optimally arranging lots of parts on raw footwear materials and cutting. A new nesting strategy was proposed for the 2-dimensional part layout by using a two-stage approach, where which can be effectively used for water jet cutting. In the initial layout stage, a SOAL(Self-Organization Assisted Layout) based on the combination of FCM(Fuzzy C-Means) and SOM was adopted. In the layout improvement stage, SA(Simulated Annealing) based approach was adopted for a finer layout. The proposed approach saves much CPU time through a two-stage approach scheme, while other annealing-based algorithm so far reported for a nesting problem are computationally expensive. The proposed nesting approach uses the stochastic process, and has a much higher possibility to obtain a global solution than the deterministic searching technique.
We developed the automatic nesting software of NST(ver.1.1) software for footwear industry by implementing of these proposed algorithms. The NST software was applied by the optimized automatic arrangement algorithm to cut without the loss of leathers, if possible, after detecting damage areas. Also, NST software can consider about several features in not only natural leathers but artificial ones. Lastly, the NST software can reduce a required time to implement generation of NC code, cutting time, and waste of raw materials because the NST software automatically performs parts arrangement, cutting paths generation and finally NC code generation, which are needed much effort and time to generate them manually.

목차 (Table of Contents)

• ABSTRACT
• 1. 서론
• 2. 자동부재배치 프로그램 개발
• 3. 결론
• 후기
• 참고문헌