Thermodynamic simulation and structural optimization of the collimator in the drift duct of EAST-NBI

Tang Ning,Hu Chun-dong,Xie Yuan-lai,Wei Jiang-long,Cui Zhi-Wei,Xie Jun-Wei,Pan Zhuo,Jiang Yao 한국원자력학회 2022 Nuclear Engineering and Technology Vol.54 No.11

The collimator is one of the high-heat-flux components used to avoid a series of vacuum and thermal problems. In this paper, the heat load distribution throughout the collimator is first calculated through experimental data, and a transient thermodynamic simulation analysis of the original model is carried out. The error of the pipe outlet temperature between the simulated and experimental values is 1.632%, indicating that the simulation result is reliable. Second, the model is optimized to improve the heat transfer performance of the collimator, including the contact mode between the pipe and the flange, the pipe material and the addition of a twisted tape in the pipe. It is concluded that the convective heat transfer coefficient of the optimized model is increased by 15.381% and the maximum wall temperature is reduced by 16.415%; thus, the heat transfer capacity of the optimized model is effectively improved. Third, to adapt the long-pulse steady-state operation of the experimental advanced superconducting Tokamak (EAST) in the future, steady-state simulations of the original and optimized collimators are carried out. The results show that the maximum temperature of the optimized model is reduced by 37.864% compared with that of the original model. The optimized model was changed as little as possible to obtain a better heat exchange structure on the premise of ensuring the consumption of the same mass flow rate of water so that the collimator can adapt to operational environments with higher heat fluxes and long pulses in the future. These research methods also provide a reference for the future design of components under high-energy and long-pulse operational conditions

Targeting treatment of bladder cancer using PTK7 aptamer-gemcitabine conjugate

Xiang Wei,Peng Yongbo,Zeng Hongliang,Yu Chunping,Zhang Qun,Liu Biao,Liu Jiahao,Hu Xing,Wei Wensu,Deng Minhua,Wang Ning,Liu Xuewen,Xie Jianfei,Hou Weibin,Tang Jin,Long Zhi,Wang Long,Liu Jianye 한국생체재료학회 2023 생체재료학회지 Vol.27 No.00

Gemcitabine (GEM) is one of the first-line chemotherapies for bladder cancer (BC), but the GEMs cannot recognize cancer cells and have a low long-term response rate and high recurrence rate with side effects during the treatment of BC. Targeted transport of GEMs to mediate cytotoxicity to tumor and avoid the systemic side effects remains a challenge in the treatment of BC.Based on a firstly confirmed biomarker in BC-protein tyrosine kinase 7 (PTK7), which is overexpressed on the cell membrane surface in BC cells, a novel targeting system protein tyrosine kinase 7 aptamer-Gemcitabine conjugate (PTK7-GEMs) was designed and synthesized using a specific PTK7 aptamer and GEM through auto-synthesis method to deliver GEM against BC. In addition, the antitumor effects and safety evaluation of PTK7-GEMs was assessed with a series of in vitro and in vivo assays.PTK7-GEMs can specifically bind and enter to BC cells dependent on the expression levels of PTK7 and via the macropinocytosis pathway, which induced cytotoxicity after GEM cleavage from PTK7-GEMs respond to the intracellular phosphatase. Moreover, PTK7-GEMs showed stronger anti-tumor efficacy and excellent biosafety in three types of tumor xenograft mice models.These results demonstrated that PTK7-GEMs is a successful targeted aptamer-drug conjugates strategy (APDCs) to treat BC, which will provide new directions for the precision treatment of BC in the field of biomarker-oriented tumor targeted therapy.

Analysis and Modeling of Longitudinal Deformation Profiles Considering the Reinforcement Effect of Tunnel Face in Weak Rocks

Zhi-long Wang,Ming-nian Wang,Dagang Liu 대한토목학회 2022 KSCE JOURNAL OF CIVIL ENGINEERING Vol.26 No.12

Convergence-confinement method (CCM) has become a common method for tunnel design due to its simplicity and practicality. The ground reaction curve (GRC), the support characteristic curve (SCC) and the longitudinal deformation profile (LDP) are all considered in this method. One of these is the LDP, which serves as a unique identifier for the location of the tunnel support. The installation point of the tunnel support is one of the most important outcomes of the method. LDP is more impacted by the reinforcement of the tunnel face. However, more existing LDP calculation methods do not consider the reinforcement of the tunnel face. A study on methods for calculating LDP considering the tunnel face reinforcement was carried out to address this constraint of CCM. Firstly, the transformation of tunnel face extrusion deformation and pre-convergence deformation at the tunnel face is realized in accordance with equivalent volume. Then a model of LDP with the tunnel face extrusion deformation as the variable was established considering the tunnel face reinforcement effect. The proposed model's accuracy is assessed in comparison with other typical models. We conclude with parametric analyses concerning the tunnel face reinforcement's effects on the point of support installation, as well as convergence deformation of the tunnel. By taking into account tunnel faces' reinforcement effects, tunnel support design can be more accurate, and the construction costs can be reduced.

VR 레졸버의 회전자 편심에 의한 회전자 각도 오차에 대한 연구

Zhi-Long Wang,임홍식(Hong-Sik Lim),김종희(Jong-Hee Kim),김기찬(Ki-Chan Kim) 대한전기학회 2017 대한전기학회 학술대회 논문집 Vol.2017 No.7

앤드 슬롯 누설 인덕턴스 고려한 VR 레졸버 변압비 해석기법

Zhi-Long Wang,김종희(Jong-Hee Kim ),하지웅(Ji-Woong Ha),최호영(Ho-Young Choi),김기찬(Ki-Chan Kim) 대한전기학회 2016 대한전기학회 학술대회 논문집 Vol.2016 No.10

Fault Analysis and Tolerant Control for High Speed PEMS Maglev Train End Joint Structure with Disturbance Rejection

Zhi-Qiang Wang,Zhi-Qiang Long,Xiao-Long Li 대한전기학회 2019 Journal of Electrical Engineering & Technology Vol.14 No.3

It is observed in test operation that for permanent magnet electro-magnetic suspension (PEMS) type high speed maglev train, when a single levitation unit in an end joint structure fails to work, the performance of the entire joint structure deteriorates rapidly, whereas in electro-magnetic suspension (EMS) type maglev system, there is no such phenomenon under the same failure. To solve this problem and to enhance system performance under faulty condition, fi rstly a comparative modeling of EMS and PEMS maglev end joint structure system was made to analyze the underlying reasons. Then a dynamic compensation method and a disturbance rejection method based on disturbance estimation and feedback linearization were proposed respectively. The performances of the proposed measures are verifi ed and compared in simulations.

Simultaneous Information and Power Transfer for Multi-antenna Primary-Secondary Cooperation in Cognitive Radio Networks

Zhi Hui Liu,Wen Jun Xu,Sheng Yu Li,Cheng Zhi Long,Jia Ru Lin 한국전자통신연구원 2016 ETRI Journal Vol.38 No.5

In this paper, cognitive radio and simultaneous wireless information and power transfer (SWIPT) are effectively combined to design a spectrum-efficient and energy-efficient transmission paradigm. Specifically, a novel SWIPT-based primary-secondary cooperation model is proposed to increase the transmission rate of energy/spectrum constrained users. In the proposed model, a multi-antenna secondary user conducts simultaneous energy harvesting and information forwarding by means of power splitting (PS), and tries to maximize its own transmission rate under the premise of successfully assisting the data delivery of the primary user. After the problem formulation, joint power splitting and beamforming optimization algorithms for decode-and-forward and amplify-and-forward modes are presented, in which we obtain the optimal PS factor and beamforming vectors using a golden search method and dual methods. Simulation results show that the proposed SWIPTbased primary-secondary cooperation schemes can obtain a much higher level of performance than that of non-SWIPT cooperation and non-cooperation schemes.

Computed Tomography Arteriography for Detecting the Origin of the Inferior Pyloric Artery in Patients with Gastric Cancer

Zhi-Long Wang,Ru-Lin Miao,Chao Gao,Lei Tang,Zi-Yu Li,Ying-Shi Sun,Jia-Fu Ji 대한영상의학회 2019 Korean Journal of Radiology Vol.20 No.3

Objective: To analyze the detection rate of the inferior pyloric artery (IPA) in patients with gastric cancer by computed tomography arteriography (CTA). Materials and Methods: Fifty-four patients (48 males and 6 females; mean age, 59.0 ± 1.5 years) who had undergone radical gastrectomy for gastric cancer from September 2016 to July 2017 at our institution were recruited prospectively. Patients underwent abdominal contrast-enhanced CT scans and CTA imaging reconstruction before the operation. The origin of the IPA in all cases was determined by a radiologist based on CTA images and verified by the surgeon. The accuracy of CTA in diagnosing the origin of the IPA was calculated. Dominant vessels of the origin were analyzed. Results: IPAs were detected by CTA in 51 patients (94.4%). Among these, IPAs originated from the right gastroepiploic artery (RGEA) (24 cases), the gastroduodenal artery (GDA) (4 cases), and the anterior superior pancreaticoduodenal artery (ASPDA) (20 cases). In the remaining 3 cases, the IPAs contained two branches originating from the RGEA and ASPDA, respectively. During surgery, in 2 (3.7%) of the 54 cases of gastric cancer, IPAs could not be detected; the IPAs originated from the RGEA (22 cases), GDA (5 cases), and ASPDA (24 cases). One case had an IPA originating from both the RGEA and the GDA. Finally, the accuracy of CTA in diagnosing the origin artery of the IPA was 85.2% (46/54). Conclusion: CTA can detect the origin of the IPA accurately, which can aid surgeons while performing pylorus-preserving operations.

An Analytical Method for Transformer Ratio of Variable Reluctance Resolver Considering End Slot Leakage Inductance

Zhi-Long Wang,Jong-Hee Kim,Ji-Woong Ha,Ki-Chan Kim 한국콘텐츠학회 2016 한국콘텐츠학회 ICCC 논문집 Vol.2016 No.12

Genetic Analysis of Growth Response to Cold Water Irrigation in Rice

Long-Zhi Han,Hee-Jong Koh 韓國作物學會 2000 Korean journal of crop science Vol.45 No.1

This study was carried out to obtain the basic information for breeding cold-tolerant rice varieties with high yield-productivity through wide crosses between indica and japonica rice. Genetic analysis was conducted using 55 F1 s obtained from half-diallel crosses among eleven cultivars of various origin including indica and japonica rice. Screening for cold tolerance was done with cold-water irrigation after transplanting until ripening stage. Both general combining ability (GCA) and specific combining ability (SCA) effects were highly significant in all characters associated with dry matter accumulation at 30 and 50days after cold-water irrigation (DAC). The variance of GCA was much larger than that of SCA in plant height, shoot dry weight per plant (DWP), crop growth rate (CGR) and cold-water response index (CRI) of these characters except CRI of shoot dry weight per plant. The DWP, CGR and CRI of these characters of Gaochan 102, Tong88-7 and TR22183 were markedly higher than those of the others. GCA effects of these varieties on DWP, CGR and their CRI were also higher than those of the others, indicating that they are useful as promising parents for breeding cold-tolerant varieties. Analysis of genetic parameters for 11~times 11 half-diallel F1 s revealed that inter-locus gene interaction were concerned in the expression of plant height at 50 DAC, CRI of DWP at 50 DAC, and CRI of CGR, and that intra-locus gene interaction for plant height and the other characters were partial dominance and over-dominance, respectively. Narrow-sense heritability (h2 N ) was the highest in plant height as 0.729, and the lowest in CRI of DWP at 30 DAC as 0.048, suggesting that selection for cold tolerance will be quite effective in case that the selection criterion is the performance itself.f.