Synthesis of CuIn_1-xGa_xSe₂ Nanoparticles by Thermal Decomposition Method with Tunable Ga Content

Latha, M.,Devi, R. Aruna,Velumani, S.,Oza, Goldie,Reyes-Figueroa, P.,Rohini, M.,Becerril-Juarez, I. G.,Yi, Junsin American Scientific Publishers 2015 Journal of Nanoscience and Nanotechnology Vol.15 No.11

<P>Chalcopyrite CuIn1-xGaxSe2 (CIGS) nanoparticles were synthesized by mixing copper (I) chloride (CuCl), Indium (III) chloride (InCl3), gallium (III) chloride (GaCl3) and selenium (Se) in oleylamine (OLA) at 260 degrees C for 4 h under nitrogen atmosphere. The Ga/(In + Ga) ratio was tuned across the entire stoichiometric range from 0 to 1. X-ray diffraction analysis (XRD) revealed chalcopyrite crystal structure for samples prepared with x = 0, 0.3, 0.5, 0.7 and 1. The lattice parameters a and c decreased linearly with increasing Ga concentration which is consistent with Vegard's law. Raman spectra exhibited A(1) optical phonon vibrational mode for synthesized nanoparticles which gradually shifted to higher wavenumber with increasing Ga content. Field emission scanning electron microscopy (FE-SEM) and transmission electron microscopy (TEM) images showed irregular as well as hexagonal plate like morphologies in the size range of 100 to 400 nm. High-resolution transmission electron microscopy (HR-TEM) images showed well-defined lattice fringes and d-spacing correspond to (112) plane which gradually decreases with increasing Ga content. The material compositions of synthesized CIGS nanoparticles with x = 0, 0.3, 0.5, 0.7 and 1 were very close to the desired stoichiometry which was confirmed by energy dispersive X-ray analysis (EDAX). Ultra-violet visible near infrared (UV-VIS-NIR) absorption spectra of the synthesized CIGS nanoparticles revealed that the bandgap could be tuned over the range 1 to 1.7 eV by varying the Ga/(In+Ga) ratio.</P>

Design of geocell reinforcement for supporting embankments on soft ground

Latha, G. Madhavi Techno-Press 2011 Geomechanics & engineering Vol.3 No.2

The methods of design available for geocell-supported embankments are very few. Two of the earlier methods are considered in this paper and a third method is proposed and compared with them. In the first method called slip line method, plastic bearing failure of the soil was assumed and the additional resistance due to geocell layer is calculated using a non-symmetric slip line field in the soft foundation soil. In the second method based on slope stability analysis, general-purpose slope stability program was used to design the geocell mattress of required strength for embankment. In the third method proposed in this paper, geocell reinforcement is designed based on the plane strain finite element analysis of embankments. The geocell layer is modelled as an equivalent composite layer with modified strength and stiffness values. The strength and dimensions of geocell layer is estimated for the required bearing capacity or permissible deformations. These three design methods are compared through a design example. It is observed that the design method based on finite element simulations is most comprehensive because it addresses the issue of permissible deformations and also gives complete stress, deformation and strain behaviour of the embankment under given loading conditions.

Optimization of Data Placement using Principal Component Analysis based Pareto-optimal method for Multi-Cloud Storage Environment

Latha, V.L. Padma,Reddy, N. Sudhakar,Babu, A. Suresh International Journal of Computer ScienceNetwork S 2021 International journal of computer science and netw Vol.21 No.12

Now that we're in the big data era, data has taken on a new significance as the storage capacity has exploded from trillion bytes to petabytes at breakneck pace. As the use of cloud computing expands and becomes more commonly accepted, several businesses and institutions are opting to store their requests and data there. Cloud storage's concept of a nearly infinite storage resource pool makes data storage and access scalable and readily available. The majority of them, on the other hand, favour a single cloud because of the simplicity and inexpensive storage costs it offers in the near run. Cloud-based data storage, on the other hand, has concerns such as vendor lock-in, privacy leakage and unavailability. With geographically dispersed cloud storage providers, multicloud storage can alleviate these dangers. One of the key challenges in this storage system is to arrange user data in a cost-effective and high-availability manner. A multicloud storage architecture is given in this study. Next, a multi-objective optimization problem is defined to minimise total costs and maximise data availability at the same time, which can be solved using a technique based on the non-dominated sorting genetic algorithm II (NSGA-II) and obtain a set of non-dominated solutions known as the Pareto-optimal set.. When consumers can't pick from the Pareto-optimal set directly, a method based on Principal Component Analysis (PCA) is presented to find the best answer. To sum it all up, thorough tests based on a variety of real-world cloud storage scenarios have proven that the proposed method performs as expected.

Stability analysis of a rock slope in Himalayas

Latha, Gali Madhavi,Garaga, Arunakumari Techno-Press 2010 Geomechanics & engineering Vol.2 No.2

Slope stability analysis of the right abutment of a railway bridge proposed at about 350 m above the ground level, crossing a river and connecting two huge hillocks in the Himalayas, India is presented in this paper. The site is located in a highly active seismic zone. The rock slopes are intensely jointed and the joint spacing and orientation are varying at different locations. Static slope stability of the rock slope is studied using equivalent continuum approach through the most commonly used commercial numerical tools like FLAC and SLOPE/W of GEOSTUDIO. The factor of safety for the slope under static conditions was 1.88 and it was reduced by 46% with the application of earthquake loads in pseudo-static analysis. The results obtained from the slope stability analyses confirmed the global stability of the slope. However, it is very likely that there could be possibility of wedge failures at some of the pier locations. This paper also presents the results from kinematics of right abutment slope for the wedge failure analysis based on stereographic projections. Based on the kinematics, it is recommended to flatten the slope from 50o to 43o to avoid wedge failures at all pier locations.

Simple Self Trap Cropping System to Control Tukra Mealy Bug (Maconellicoccus hirsutus Green) Incidence on Mulberry (Morus spp.)

Latha, K. Lavanya,Rao, T.V.S.S.,Rao, J. V. Krishna,Jayaraj, S.,Reddy, N. Sivarami,Naik, S. Sankar Korean Society of Sericultural Science 2008 International Journal of Industrial Entomology Vol.17 No.2

A field study on self trap cropping system in controlling tukra mealy bug Maconellicoccus hirsutus Green) incidence on mulberry (Morus spp.; V-1 variety; $3'{\times}3'$ spacing) gardens was undertaken in selected sericulture farmers' mulberry gardens of Pydeti village (Parigi Mandal, Anantapur District, Andhra Pradesh, India). The study was conducted for three years (2004, 2005 and 2006). Four treatments (T0; control/no treatment, T1; self trap cropping rows with 10 row interval, T2; self trap cropping rows with 10 row interval and treating these rows only with 0.5% neem oil emulsion and T3; self trap cropping rows with 10 rows intervals and treating all the mulberry rows including self trap cropping rows with 0.5% neem oil emulsion) were considered. The results indicated that the incidence increased in T0 and T1 while the same suppressed in T2 and T3. The suppression (%) of tukra incidence between T2 and T3 was not significant. Hence, T2 only was recommended to farmers as its economical viable practice. The results are discussed based on the importance of tukra, its suppression and cost of treatment.

A Solid State Reactive Power Compensator

E. Latha Mercy,S.Saravanan 전력전자학회 2004 ICPE(ISPE)논문집 Vol.- No.-

An instantaneous reactive power compensator is presented and analyzed in this paper. It operates without sensing the reactive<br/> power demand and nonlinearities present in the load. An instantaneous compensation feature is achieved without employing any complicated control logic. The compensator is operated in discrete mode to achieve the instantaneous compensating feature.<br/>

Notes : Simple Self Trap Cropping System to Control Tukra Mealy Bug (Maconellicoccus hirsutus Green) Incidence on Mulberry (Morus spp.).

( K. Lavanya Latha ),( T. V. S. S. Rao ),( J. V. Krishna Rao ),( S. Jayaraj ),( N. Sivarami Reddy ),( S. Sankar Naik ) 한국잠사학회 2008 International Journal of Industrial Entomology Vol.17 No.2

A field study on self trap cropping system in controlling tukra mealy bug Maconellicoccus hirsutus Green) incidence on mulberry (Morus spp.; V-1 variety; 3`x3` spacing) gardens was undertaken in selected sericulture farmers` mulberry gardens of Pydeti village (Parigi Mandal, Anantapur District, Andhra Pradesh, India). The study was conducted for three years (2004, 2005 and 2006). Four treatments (T0; control/no treatment, T1; self trap cropping rows with 10 row interval, T2; self trap cropping rows with 10 row interval and treating these rows only with 0.5% neem oil emulsion and T3; self trap cropping rows with 10 rows intervals and treating all the mulberry rows including self trap cropping rows with 0.5% neem oil emulsion) were considered. The results indicated that the incidence increased in T0 and T1 while the same suppressed in T2 and T3. The suppression (%) of tukra incidence between T2 and T3 was not significant. Hence, T2 only was recommended to farmers as its economical viable practice. The results are discussed based on the importance of tukra, its suppression and cost of treatment.

ON FUZZY SEMI α - SEPARATION TOPOLOGICAL SPACES

Othman,Latha 장전수학회 2009 Proceedings of the Jangjeon mathematical society Vol.12 No.3

This paper is devoted to introduce and investigate all types of fuzzy semi α- separation topological spaces. Properties and relationship of fuzzy semi α - separation topological spaces are investigated.

Antimicrobial and Micro Raman Spectroscopy of Selected Zingiberaceae Species from Northeast India

Archana Das,Latha Rangan,Vigya Kesari,Arpita Nath,Alika Khare 한국작물학회 2013 Journal of crop science and biotechnology Vol.16 No.1

Antimicrobial activity of crude rhizome oils from some important members of Zingiberaceae from Northeast India was carried out in the present study. The plants used were Curcuma amada, C. longa, Zingiber moran, and Z. zerumbet. Rhizomes of the four species were collected and rhizome oil was extracted using six different polar and non-polar solvents. The antimicrobial property of the crude oil was studied against human pathogens using disc-diffusion and viability assay. The rhizome oil of all the 24 extracts exhibited potent antimicrobial activity against all pathogenic bacterial and fungal strains tested. Hydrodistilled fractions of the four species studied showed better effect among all solvents. Water extract of Z. moran was found to be the highest effective antimicrobial agent of all. Antibacterial effect of the water fractions was also characterized against Gram-positive and Gram-negative bacteria using micro Raman spectroscopy. This investigation shows that the essential oils from the wild and domestic species of the family Zingiberaceae from Northeast India are a potential source of bioactive compounds with tremendous medicinal, economic, and therapeutic value. The wild and endemic species Z. moran represents an interesting and promising source of plant-derived antimicrobial agent in the development of new drugs against pathogens.

Evaluation of penetration depth of 2% chlorhexidine digluconate into root dentinal tubules using confocal laser scanning microscope

Vadhana, Sekar,Latha, Jothi,Velmurugan, Natanasabapathy The Korean Academy of Conservative Dentistry 2015 Restorative Dentistry & Endodontics Vol.40 No.2

Objectives: This study evaluated the penetration depth of 2% chlorhexidine digluconate (CHX) into root dentinal tubules and the influence of passive ultrasonic irrigation (PUI) using a confocal laser scanning microscope (CLSM). Materials and Methods: Twenty freshly extracted anterior teeth were decoronated and instrumented using Mtwo rotary files up to size 40, 4% taper. The samples were randomly divided into two groups (n = 10), that is, conventional syringe irrigation (CSI) and PUI. CHX was mixed with Rhodamine B dye and was used as the final irrigant. The teeth were sectioned at coronal, middle and apical levels and viewed under CLSM to record the penetration depth of CHX. The data were statistically analyzed using Kruskal-Wallis and Mann-Whitney U tests. Results: The mean penetration depths of 2% CHX in coronal, middle and apical thirds were $138{\mu}m$, $80{\mu}m$ and $44{\mu}m$ in CSI group, respectively, whereas the mean penetration depths were $209{\mu}m$, $138{\mu}m$ and $72{\mu}m$ respectively in PUI group. Statistically significant difference was present between CSI group and PUI group at all three levels (p < 0.01 for coronal third and p < 0.001 for middle and apical thirds). On intragroup analysis, both groups showed statistically significant difference among three levels (p < 0.001). Conclusions: Penetration depth of 2% CHX into root dentinal tubules is deeper in coronal third when compared to middle and apical third. PUI aided in deeper penetration of 2% CHX into dentinal tubules when compared to conventional syringe irrigation at all three levels.