http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
새로운 글로우 방전/유도결합 플라스마 장치(GD/ICP Interface)에 대한 기초 연구: Part Ⅰ. 기초 연구
이계호,김형성,길효식,Lee, Gae Ho,Kil, Hyo Shik,Kim, Hyung Seung,Gary M. Hieftje 대한화학회 1999 대한화학회지 Vol.43 No.2
글로우 방전(Glow Discharge, GD)과 유도결합플라스마(Inductively Coupled Plasma, ICP)-원자 방출분광법(Atomic Emission Spectrometer, AES)에서 사용되는 새로운 장치를 개발하였다. ICP-AES에서 GDAES로 전환하는 데 불과 15분 정도 소요되기 때문에, 고체 시료 및 액체시료에 포함된 극미량 원소분석을 신속하게 수행할 수 있다. 실험변수 중에서 냉각기체 유속, 시료운반기체 유속, 절단기체 유속, 보조기체 유속, 측정깊이, 이온 통과관 크기, 그리고 rf 전원의 세기 변화에 따른 원자 방출 복사선 변화에 미치는 영향을 조사 연구하였다. Cd(I) 228.8 nm, Mn(II) 257.61 nm, and Fe(II) 259.95 nm에서 측정한 검출한계는 각각 3.86, 1.49, 5.79 ppb로 측정되었으며, 직선성은 1.000으로서 우수하였다. The new GD/ICP-AES quick change over system has been developed and characterized. Within less than 15 minutes, ICP-AES could be switched to GD-AES and vise a versa. As a result, both solid and liquid samples could be analyzed in a very short period of time by the ICP/GD-AES quick change over system developed in our laboratory. The influences of the experimental variables, such as flow rate of coolant gas, flow rate of auxiliary gas, flow rate of sample carrier gas, sampling depth, orifice size of sampling cone, and rf (radio frequency) power on emission intensity have been presented. The detection limits of Cd(I) 228.8 nm, Mn (II) 257.61 nm, and Fe(II) 259.95 nm were found to be 3.86, 1.49, and 5.79 ppb, respectively. And linealities of the calibration curves were measured to be unity.
열분해-가스크로마토그래피/질량분석법에 의한 가황고무중의 유기첨가제의 직접분석
김승욱,허귀석,이계호,Kim, Seung Wook,Heo, Gwi Suk,Lee, Gae Ho 대한화학회 1997 대한화학회지 Vol.41 No.10
Analysis of additives in cured rubber is often a difficult task for analytical chemists because of a wide variety of complex components. Conventional analyses of additives and rubbers have been done in multistep, off-line processes with large sample size and extensive sample preparations. The coumarone-indene resin, resorcinol-formaldehyde resin, and prevulcanization inhibitor have been characterized by their pyrolysis pathways and mass spectra of characteristic pyrolyzates. Pyrolysis Gas Chromatography/Mass Spectrometry (Py-GC/MS) was used in the identification of additives without any sample pretreatment. This result shows that several organic additives in cured rubber can be directly analyzed. 고무가황체는 고분자인 천연고무 및 합성고무에 여러 가지 유기첨가제를 배합하여 만든다. 이와 같은 배합고무의 분석은 여러 가지 다른 성질을 갖는 다양한 첨가제들로 인하여 많은 전처리 과정을 거쳐야 하므로 그 분석이 용이하지 않다. 이를 극복하기 위하여 열분해 가스크로마토그래피질량분석법(Pyrolysis Gas Chromatography-Mass Spectrometry)을 이용하여 고무가황체 중의 유기 고무약품들의 직접분석을 시도하였다. 점착제인 쿠마론-인덴수지(coumarone-indene resin $C-90^{TM}$), 접착제인 알킬페놀 레조시놀 포름알데히드 수지, 가류지연제 등의 고무첨가제의 열분해과정 및 열분해체들의 질량스펙트럼들을 확인하였고 이를 통하여 복잡한 구성 성분으로 이루어진 가황고무 중에서 이들 배합제의 직접분석이 가능하였다.
한국형 총식이조사에 근거한 우리 국민의 식품 기인 요오드 섭취량 추정
이지연(Jeeyeon Lee),여윤재(Yoonjae Yeoh),서민정(Min Jeong Seo),이계호(Gae Ho Lee),김초일(Cho-il Kim) 대한지역사회영양학회 2021 대한지역사회영양학회지 Vol.26 No.1
Objectives: This study was conducted to estimate the dietary iodine intake of Koreans by a Total Diet Study (TDS) which provides ‘closer-to-real’ estimates of exposure to hazardous materials and nutrients through an analysis of table-ready (cooked) samples of foods. Methods: Dietary intake data from 2013-2017 Korea National Health and Nutrition Examination Survey (KNHANES) was used to select representative foods (RFs) for iodine analysis. A total of 115 RFs were selected and 158 ‘RF × cooking method-combination’ pairs were derived by pairing each RF to corresponding cooking method(s) used more frequently. RFs were collected from 9 mega-markets in 9 metropolitan cities nationwide and mixed into composites prior to cooking preparation to a ‘table ready’ state for iodine analysis by inductively coupled plasma mass spectrometry. Iodine intake of Koreans was estimated based on the food intake data of the 2016-2018 KNHANES. Results: High iodine content was detected in seaweeds such as sea mustard and kelp. The mean iodine intake/capita/day was 418.4 μg and the median value was 129.0 μg. Seaweeds contributed to 77.4% of the total iodine intake and the contribution by food item was as follows: sea mustard (44.0%), kelp (20.4%), laver (13.1%), milk (3.9%), egg (3.5%). Compared to the Dietary Reference Intakes for Koreans 2020, the proportion of people with iodine intake exceeding the tolerable upper intake level or below the estimated average requirement was high in the physiologically vulnerable groups (infants, children, pregnant women, and lactating women). Conclusions: The results, drawn from a TDS, are regarded closer to real estimates for iodine intake of Koreans compared with values in existing literature, which were based on a very limited variety of foods. On the other hand, it seems necessary to seek out solutions for the problematic iodine intake among physiologically vulnerable groups through in-depth analyses on food intake data collected with significant scale & quality.
박현주,김경숙,양석란,이계호,Park, Hyun Joo,Kim, Kyeong Sook,Yang, Seug Ran,Lee, Gae Ho 대한화학회 2000 대한화학회지 Vol.44 No.6
화력발전소에서 사용되는 석탄중의 회성분 분석은 노내에서의 슬래깅성(slagging), 파울링성(fouling), 마모성 및 집진성 등을 예측하거나 구성성분에 따라 석탄의 적정 혼탄비율을 결정하는데 유용하게 사용되므로 매우 중요하다. 현재 ASTM에서는 석탄회 분석법은 용융법에 의해 전처리한 후 AAS(Atomic Absorption Spectrometer)로 분석하는 것으로 규정하고 있으나, 이 분석법은 시료의 수가 많은 경우에 상당한 시간과 노력을 필요로 하여 한전의 모든 발전소의 분석업무를 담당하고 있는 본 연구실의 경우에는 적합하지 않다. 따라서, 정확하고 신속한 분석방법을 개발하기 위하여 시료를 LiBO$_2$를 사용한 용융법과 마이크로파을 이용한 용해법으로 전처리를 한 다음 ICP를 사용하여 분석한 결과와 석탄회 시료를 투명한 pellet으로 만들어 XRF로 분석한 결과를 비교${\cdot}$검토하였다. 이번에 확립된 두 가지 전처리법에 의한 ICP 분석과 XRF 방법 모두 석탄회의 주요 성분을 분석하는 데 유용하게 사용할 수 있는 분석방법임을 확인할 수 있었고, 각각의 방법은 장${\cdot}$단점을 가지고 있으므로 사용목적에 따라 적절히 활용될 수 있다. The analysis of coal ash is very important to predict some factors, such as slagging and fouling in the boiler, and to determine optimum mixing ratios of the each coals used. In ASTM, the analysis of coal ash is clarified to use lithium metaborate (LiBO$_2$) as a fluxing agent and then to analyze the pre-treated samples using AAS. However, it takes too much time and efforts to analyze many samples by ASTM method, as a result, this method is not proper in our laboratory in charge of analyses of all power plants. So we tried to establish more convenient and accurate analytical method of coal ash by 3 different methods which are 2 different pre-treatment methods (fusion dissolution and microwave digestion) and XRF analysis method using a clear pellet. Although all 3 methods can be utilized to analyze the major elements of coal ash, each method has its own characteristics, therefore, each method should be chosen according to its own purpose.