http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
Kento Igarashi, Tetsuo Yamada,Masato Inoue 대한산업공학회 2014 Industrial Engineeering & Management Systems Vol.13 No.1
Promotion of a closed-loop supply chain requires disassembly systems that recycle end-of-life (EOL) assembled products. To operate the recycling disassembly system, parts selection is environmentally and economically carried out with non-destructive or destructive disassembly, and the recycling rate of the whole EOL product is determined. As the number of disassembled parts increases, the recycling rate basically increases. However, the labor cost also increases and brings lower profit, which is the difference between the recovered material prices and the disassembly costs. On the other hand, since the precedence relationships among disassembly tasks of the product also change with the parts selections, it is also required to optimize allocation of the tasks in designing a disassembly line. In addition, because information is required for such a design, the recycling rate, profit of each part and disassembly task times take precedence among the disassembly tasks. However, it is difficult to obtain that information in advance before collecting the actual EOL product. This study proposes and analyzes an optimal disassembly system design using integer programming with the environmental and economic parts selection (Igarashi et al., 2013), which harmonizes the recycling rate and profit using recyclability evaluation method (REM) developed by Hitachi, Ltd. The first stage involves optimization of environmental and economic parts selection with integer programming with ε constraint, and the second stage involves optimization of the line balancing with integer programming in terms of minimizing the number of stations. The first and second stages are generally and mathematically formulized, and the relationships between them are analyzed in the cases of cell phones, computers and cleaners.
Synthesis and photochemical properties of α-diketoporphyrins as precursors for π-expanded porphyrins
Yamada, Hiroko,Kuzuhara, Daiki,Ohkubo, Kei,Takahashi, Tetsuro,Okujima, Tetsuo,Uno, Hidemitsu,Ono, Noboru,Fukuzumi, Shunichi The Royal Society of Chemistry 2010 Journal of materials chemistry Vol.20 No.15
<p>A new α-diketoporphyrin and the corresponding Pd complex were prepared from the monoanthroporphyins and their photochemical properties were investigated by measurements of absorption and emission spectra, fluorescence lifetimes, laser flash photolysis, cyclic voltammetry, and theoretical calculations. Intramolecular electron transfer from the porphyrin singlet excited state to the diketone moiety was observed for the free base α-diketoporphyrin in benzonitrile, but this was not observed in toluene. Photoreactivity of the α-diketoporphyrins was also examined by irradiation at the Soret and Q bands. When the Soret band of the freebase α-diketoporphyrin was irradiated, cleavage of the diketone moiety occurred to afford the monoanthroporphyrin with the release of two CO molecules quantitatively in both benzonitrile and toluene. When the Q band of the freebase α-diketoporphyrin was irradiated, no photocleavage reaction occurred in toluene. In contrast to the freebase α-diketoporphyrin, the photocleavage reaction of the Pd complex occurred with irradiation at the Q band as well as the Soret band to afford the monoanthroporphyrin quantitatively in toluene. The photocleavage reaction proceeded much more effectively in toluene than in benzonitrile. The occurrence of rapid photoinduced electron transfer from the singlet excited state porphyrin to the diketone moiety, which was detected by femtosecond laser flash photolysis measurements, results in a significant decrease in the singlet excited state lifetime, prohibiting the photocleavage reaction in benzonitrile. Thus, the Pd α-diketoporphyrin can act as an excellent precursor for the corresponding acene in toluene. The photocleavage process provides a convenient and inexpensive method to make the thin film.</p> <P>Graphic Abstract</P><P>A new α-diketoporphyrin and its Pd complex were prepared and successfully converted into the corresponding monoanthroporphyins by photoirradiation of the porphyrin moieties with release of two CO molecules quantitatively. <img src='http://pubs.rsc.org/ej/JM/2010/b923220f/b923220f-ga.gif'> </P>
Igarashi, Kento,Yamada, Tetsuo,Inoue, Masato Korean Institute of Industrial Engineers 2014 Industrial Engineeering & Management Systems Vol.13 No.1
Promotion of a closed-loop supply chain requires disassembly systems that recycle end-of-life (EOL) assembled products. To operate the recycling disassembly system, parts selection is environmentally and economically carried out with non-destructive or destructive disassembly, and the recycling rate of the whole EOL product is determined. As the number of disassembled parts increases, the recycling rate basically increases. However, the labor cost also increases and brings lower profit, which is the difference between the recovered material prices and the disassembly costs. On the other hand, since the precedence relationships among disassembly tasks of the product also change with the parts selections, it is also required to optimize allocation of the tasks in designing a disassembly line. In addition, because information is required for such a design, the recycling rate, profit of each part and disassembly task times take precedence among the disassembly tasks. However, it is difficult to obtain that information in advance before collecting the actual EOL product. This study proposes and analyzes an optimal disassembly system design using integer programming with the environmental and economic parts selection (Igarashi et al., 2013), which harmonizes the recycling rate and profit using recyclability evaluation method (REM) developed by Hitachi, Ltd. The first stage involves optimization of environmental and economic parts selection with integer programming with ${\varepsilon}$ constraint, and the second stage involves optimization of the line balancing with integer programming in terms of minimizing the number of stations. The first and second stages are generally and mathematically formulized, and the relationships between them are analyzed in the cases of cell phones, computers and cleaners.
${29}^Si$ MAS NMR Study on Quantitative Analysis of the Amorphous Phase in a $Si_3N_4$ Powder
Fujimori, Hirotaka,Kitahara, Hiromoto,Ioku, Koji,Goto, Seishi,Nakayasu, Tetsuo,Yamada, Tetsuo The Korean Ceramic Society 2000 The Korean journal of ceramics Vol.6 No.2
NMR study has been used for measuring precise quantity of the amorphous phase in the $Si_3N_4$powder. Care must be taken to allow the $^{29}$Si nuclear spin system to fully relax between pulses in order to make the signals proportional to the number of nuclei in each phase. $^{29}$Si MAS spectrum was decomposed into the three spectra of $\alpha$-, $\beta$-, and amorphous $Si_3N_4$assuming pseudo-Voigt function. Moreover, the Rietveld analysis of the powder X-ray diffraction data was performed to measure quantity of crystalline phases as $\alpha/\beta$ ratio.
NMR Study of Successive Magnetic Transitions in the A-site Ordered Perovskite LaMn3Cr4O12
Yu Kawasaki,Syota Takase,Yutaka Kishimoto,Takashi Ohno,Ikuya Yamada,Kentaro Shiro,Ryoji Takahashi,Kenya Ohgushi,Norimasa Nishiyama,Toru Inoue,Tetsuo Irifune 한국물리학회 2013 THE JOURNAL OF THE KOREAN PHYSICAL SOCIETY Vol.63 No.3
We have investigated the successive magnetic phase transitions of the A-site ordered perovskiteLaMn3Cr4O12 by measuring 139La nuclear magnetic resonance (NMR) spectra. The successivemagnetic transitions are revealed by a very small but clear increase in the full width at half maximum(FWHM) of the 139La NMR signal at TM2 = 150 K and by the disappearance of the signal due to theline broadening at temperatures below TM1 = 50 K. These two magnetic transitions are associatedwith independent orderings within the Cr-site sublattice at TM2 and within the Mn-site sublatticeat TM1. Regarding the magnetic structure of the Cr-site sublattice at temperatures below TM2, thecancellation of internal fields at the La site, ruling out ferromagnetic and multi-q antiferromagneticstructures, is consistent with the typical antiferromagnetic structure for perovskites, such as G-,A- and C-type orders. The uncanceled internal field at the La site at temperatures below TM1is also consistent with these typical antiferromagnetic structures in the Mn-site sublattice. Thedifferences in the temperature dependences of the Knight shift K(T) and the bulk susceptibility χ(T) are consistently explained by the independent magnetic orderings of the Cr- and the Mn-sitesublattices and the cancellation of internal field originating from the Cr-site sublattice at the Lasite at temperatures below TM2.
Yoshiki Yasukoch,Jun Sakuma,Ichiro Takeuchi,Kimihiko Kato,Mitsutoshi Oguri,Tetsuo Fujimaki,Hideki Horibe,Yoshiji Yamada 생화학분자생물학회 2017 Experimental and molecular medicine Vol.49 No.-
Genome-wide association studies have identified various genetic variants associated with complex disorders. However, these studies have commonly been conducted in a cross-sectional manner. Therefore, we performed a longitudinal exome-wide association study (EWAS) in a Japanese cohort. We aimed to identify genetic variants that confer susceptibility to hypertension using ~ 244 000 single-nucleotide variants (SNVs) and physiological data from 6026 Japanese individuals who underwent annual health check-ups for several years. After quality control, the association of hypertension with SNVs was tested using a generalized estimating equation model. Finally, our longitudinal EWAS detected seven hypertension-related SNVs that passed strict criteria. Among these variants, six SNVs were densely located at 12q24.1, and an East Asian-specific motif (haplotype) ‘CAAAA’ comprising five derived alleles was identified. Statistical analyses showed that the prevalence of hypertension in individuals with the East Asian-specific haplotype was significantly lower than that in individuals with the common haplotype ‘TGGGT’. Furthermore, individuals with the East Asian haplotype may be less susceptible to the adverse effects of smoking on hypertension. The longitudinal EWAS for the recessive model showed that a novel SNV, rs11917356 of COL6A5, was significantly associated with systolic blood pressure, and the derived allele at the SNV may have spread throughout East Asia in recent evolutionary time.
A Control System for Dual-Axis Linear Motor
Yoshiyuki UCHIDA,Shigemitsu NOHIRA,Yoshiyuki SElKE,Hiroyasu SHINGU,Tetsuo SUMI,Hideo FURUHASHI,Jun YAMADA 대한전자공학회 1992 대한전자공학회 학술대회 Vol.1992 No.10
Fundamental positioning characteristics of a dual-axis Sawyer linear motor are described. The Sawyer motor is capable of high positional accuracy. An electronic control unit of the motor whose velocity is proportional to the frequency of the electric current was produced in our laboratory. The positioning system was constructed using two Sawyer motors, an air bearings suspension unit and an electronic control unit. The stable motion of the motor was confirmed on the open loop operation. The adjustable operating conditions were the live load of 1㎏, the maximum acceleration of 1.2G and the maximum velocity of 350㎜/s. Absolute positioning accuracy was improved within ±5㎛, on microstep operating conditions of dividing one pitch of 508㎛ into 508 steps. The following two conclusions were obtained. An accelerating-cruising-decelerating control is effective for reduction in the travel time required. Also, microstep operation is effective for improving the resolution of position.