http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
최연성,이건목,이건휘,김도호 대한침구의학회 2009 대한침구의학회지 Vol.26 No.1
Objectives : The purpose of this study is to investigate the mechanism and effect of moxa bucket moxibustion, to be used as the quantitative data through the measurement of temperature, and to grasp the thermodynamic characteristics of moxa bucket moxibustion. Methods : We have selected the moxa bucket moxibustion. We have made a comparative study of the thermodynamic characteristics of moxa bucket moxibustion. We have examined combustion times, temperatures, temperature gradients in each period during a combustion of moxa bucket moxibustion made by oak wood. Results : 1. We could design the moxa bucket moxibustion so that it has 57.6℃ maximum temperature with 7g weight and 10mm height, if we use more weight of moxa or lower height of moxa, we can observe relatively elevated maximum temperature. We observed the maximum temperature following the measuring position of moxa bucket and we could see higher temperature at the center of the moxa bucket and lower temperature at the side of the moxa bucket. 2. We could design the moxa bucket moxibustion with 5g moxa and 10mm height so that it has 0.121℃/sec of maximum temperature gradient, and it has relatively high temperature gradient at lower weight and height condition. 3. We could design the moxa bucket moxibustion with 7g moxa and 15mm height so that it has 4,135sec of the longest effective temperature combustion time. If we use more weight of moxa or higher height of moxa, we can observe relatively extended effective temperature combustion time. Conclusions : We observed the longest effective combustion time following the measuring position of moxa bucket. We can see a higher temperature at the center of the moxa bucket and a lower temperature at the side of the moxa bucket.
최연성,왕쩐후안,권영철 한국기계기술학회 2019 한국기계기술학회지 Vol.21 No.3
In this study, the performances of the refrigeration unit for the box under actual operating conditions were examined by using the constant temperature and humidity chamber (air enthalpy method). For this purpose, the degree of superheat, pressure, and temperature were measured while changing the EEV opening, the compressor speed, the outdoor temperature, and the load in the refrigeration cycle of the refrigeration unit. The highest cooling performance was found at EEV 33%. However, EEV 35% with low compression ratio and degree of superheat was the most reliable in terms of reliability. Considering the compressor speed and cooling performance, the refrigeration unit was in an optimal condition at the compressor speed 3,040RPM. The results of this study will be provided as basic data for the optimal design of refrigeration units for box.
최연성,권영철 한국기계기술학회 2019 한국기계기술학회지 Vol.21 No.5
In this study, the change of cooling water temperature (72, 85, 95 ℃) and engine speed (1,800, 2,000, 2,200, 2,400rpm) were experimentally investigated to confirm the operation performance characteristics of auxiliary engine for refrigeration unit. The experimental setup consisted of fuel consumption meter, power meter, and heat transfer unit. The operation performances such as BSFC, exhaust temperature, power generation, and engine efficiency of the auxiliary engine showed similar characteristics in the present experimental range, according to the change of cooling water temperatures and rpms. As the torque increased, the BSFC decreased significantly and the exhaust temperature increased. The power generation increased linearly and the efficiency was insignificant at more than 40 Nm torque.
분자영상 방사성추적자의 생산에 사용되는 방사성동위원소 표지방법
최연성 대한핵의학회 2004 핵의학 분자영상 Vol.38 No.2
Molecular imaging visualizes cellular processes at a molecular or genetic level in living subjects, and diverse molecular probes are used for this purpose. Radiolabeling methods as well as radioisotopes are very important in preparation of molecular probes, because they can affect the biodistribution in tissues and the excretion route. In this review, the molecular probes are divided into small organic molecules and macromolecules such as peptides and proteins, and their commonly used radiolabeling methods are described. (Korean J Nucl Med 38(2):121-130, 2004)
Molar activity of radiopharmaceuticals
최연성 대한방사성의약품학회 2018 Journal of radiopharmaceuticals and molecular prob Vol.4 No.1
Radiopharmaceuticals are used for diagnosis or therapy of diseases. According to the recent consensus nomenclature rules for radiopharmaceutical chemistry, specific activity is defined as the radioactivity per gram of radiolabeled compound and molar activity as the radioactivity per mole of radiolabeled compound. In this review, molar activity of radiopharmaceuticals is discussed in terms of its significance in nuclear imaging as well as its measurement methods.
10kW급 냉동유닛용 응축기의 성능특성에 대한 최적화 연구
최연성,권영철 한국기계기술학회 2019 한국기계기술학회지 Vol.21 No.2
In this study, the cooling capacity and the pressure drop of a condenser for 10kW refrigerator unit were experimentally investigated. The performance characteristics of the condenser was studied by changing the fin shape(4 types), fin pitch(5 types), tube row(4 types) and air flow rate(6 types), using the calorimeter. The optimum heat exchanger specifications were selected by comparing the capacity and the pressure drop of the condenser. In order to select the heat exchanger suitable for the condenser for 10kW refrigerator unit, both the cooling capacity and the pressure drop should be considered. From the condenser performance test by pin type, the wavy pin was selected. The optimal performance of the condenser for 10kW refrigerator unit was observed at the fin pitch of 3 mm, the tube row of 4 row, and the air flow rate of 90㎥/min.