http://chineseinput.net/에서 pinyin(병음)방식으로 중국어를 변환할 수 있습니다.
변환된 중국어를 복사하여 사용하시면 됩니다.
윤종호 경일대학교 산업기술연구소 1994 産業技術硏究所 論文集 Vol.4 No.-
Many studies on the machine condition monitoring have been performed because they give many benefits such s, increased machine availability, decreased maintenance cost, improved quality, reduced unscheduled downtime, improved safety, reduced stock holdings, etc. Most of them, however, are basic and simple, and the study on the statistical algorithm for automatic comparison and decision has not been carried out, yet. Therefore, in this study, the developments of diagnostic techniques and automatic diagnosis system were done for the purpose of efficient maintenance of machine and its quality control. The subjectives and results performed in this study for the automatic diagnosis of rolling element bearing, are as follows. The test rolling element bearings with various kinds of defects were prepared for the pattern analyses of bearing defects. In order to optimize decision level, decision analysis was applied. The pattern analyses according to defects are performed for the purpose of defect detection. the frequency bandwidth of reference spectrum was calculated statistically, and this calculation was based on the defect characteristic values and experimental measurements, and the result of diagnosis is expressed probabilitically by was of data-base of vibration level obtained experimentally according to frequency bands.
시각 동기된 다중 양방향 TMDS 데이터 전송기능을 갖는 IED용 TSMB 버스 시스템의 구현 및 성능분석
윤종호,황병창,민병기,김동준 대한전기학회 2023 전기학회논문지 Vol.72 No.1
In this paper, we propose a novel TSMB bus system with multiple bidirectional data transmission and time synchronization capability for IEDs(Intelligent Electronic Devices). Unlike the legacy unidirectional TMDS(Transition Minimized Differential Signaling) used for transfer digital video signals, the proposed bus system employs dual high-speed serial TMDS link for sending trigger signals from the FPGA of main processor module and receiving the sampled data from submodules such as either current or potential transformers. For simultaneous triggering multiple submdoules, we also employ the precision timing protocol processing capability in the main processor, which generates the wall clock pulse per second(PPS) synchronized to GPS. Adopting PLL for the PPS signal, we can provide the reference clock of 98.304MHz for supporting the data rate of 491.52 Mbps over each TMDS link. The data rate can support eight 24 bits ADCs for PTs or CTs in the single link, each of which requires 4800 samplings per second. An implemented TSMB bus system with FPGA consists of a single main processor with clock expander and eight submodules, in which each submodule is connected with the bidirectional TMDS link to the FPGA of main processor module. The jitter of 1 PPS between the two main processor modules was measured to be less than 102nsec at the maximum, and the jitter of the TSMB transmission data line was measured to be less than or equal to 660ps at the TP3 point of the receiving side, confirming that the TMDS specification was satisfied. Finally, the proposed time- synchronized multi-directional bus system can contribute to the improvement of the reliability and performance of the algorithm of the intelligent protection relay system through the optimal transmission of equivalent and simultaneous sampling data without the involvement of the processor.
지속가능미래를 위한 신재생에너지 응용 친환경건축 방향 - 7. BiWP, 건물일체형 풍력 발전 시스템의 새바람
윤종호,Yoon, Jong-Ho 대한건축사협회 2008 建築士 Vol.2008 No.11
1970년 초에 배럴당 1불하던 원유가가 지금은 120불을 상회하고 있다. 더욱 놀라운 것은 3년 전만 하더라도 40불 이하 수준이던 것이 불과 몇 년 사이에 3배 이상 급등해 버린 것이다. 우리는 아직 유가 100불 이상의 고유가 시대에 대한 고통을 실감하지 못하고 있지만, 빠른 시일 안에 대항한 형태로 우리를 불편하게 하고, 더가서는 사회 경제 문화 등 모든 우리의 활동패턴에 근본적 변화를 일으킬 것이라는데는 어느 누구도 이의를 달지 못할 것이다. 한편 90년대만 하더라도 친환경 건축기술은 선택적 사양으로 인식되어 왔으며, 일부 고급건물 또는 데모성격의 건물에만 반영되던 미래의 기술 분야로 간주되어왔다. 하지만 10년 남짓 지난 지금 우리 주변에서 가장 흔하게 접할 수 있는 용어 중의 하나가 친환경, 지속가능, 그린, 에코 등 이며, 최근 많은 건설사가 고민하고 있는 가장 중요한 이슈가 친환경 건축 관련 기술이 되어버렸다. 최근 유가의 급등세 보다는 더디다 할 지라도 몇 년 사이에 벌어지고 있는 제도적, 사회 경제적 변화 동향을 돌이켜 볼 때 건축계 또한 매우 빠른 속도로 변해가고 있으며, 부지불시간에 유가등급과 같이 변화된 환경에 놀라는 시기가 곧 도래할 것이다. 오랜 기간 에너지 및 친환경 관련 요소기술의 개발, 정부의 지원제도 확대, 보급 강화 등 각종 노력을 통해 이제는 건축 설계분야에서도 친환경건축물에 대한 저변이 크게 확대되었다고 볼 수 있다. 하지만 실상 우리주변에서 제대로된 친환경 건축물을 실제로 보고자 한다면 두손으로 꼽기도 힘들 정도인 사실에 놀라게 될 것이다. 이러한 배경하에 이번 연재에서는 그동안 오랜기간 떠들고 노력했음에도 불구하고 실제 제대로된 친환경 건축물을 우리 주변에서 찾기 힘든 이유를 건축실무자 측면에서 재고해 보고, 이에 대한 새로운 해결방안을 모색해 보는 계기를 갖고자 한다. 특히 많은 친환경 건축기술 중 최근 선진국을 중심으로 가장 큰 이슈가 되어 있고, 또한 건축사 입장에서 쉽게 접근하기 어려운 기술분야인 신재생에너지 건축응용 측면에서 다양한 최신 기술 및 실질적 접근방법과 사례를 주제별로 제시하고자 한다.
440℃와 500℃에서 액체카드뮴음극을 이용한 우라늄 전착에 관한 연구
윤종호,김시형,김가영,김택진,안도희,백승우,Yoon, Jong-Ho,Kim, Si-Hyung,Kim, Gha-Young,Kim, Tack-Jin,Ahn, Do-Hee,Paek, Seungwoo 한국방사성폐기물학회 2013 방사성폐기물학회지 Vol.11 No.3
Electrowinning process in pyroprocessing recovers U (uranium) and TRU (Trans Uranium) elements simultaneously from spent fuels using a liquid cadmium cathode (LCC). When the solubility limit of U deposits over 2.35wt% in Cd, U dendrites were formed on the LCC surface during the electrodeposition at $500^{\circ}C$. Due to the high surface area of dendritic U, the deposits were not submerged into the liquid cadmium pool but grow out of the LCC crucible. Since the U dendrites act as a solid cathode, it prevents the co-deposition of U and TRUs. In this study, the electrodeposition of U onto a LCC was carried out at 440 and $500^{\circ}C$ to compare the morphology and component of U deposits. The U deposits at $440^{\circ}C$ have a specific shape and were stacked regularly at the center of the LCC pool, while the U dendrites (i.e., ${\alpha}$-phase) at $500^{\circ}C$ were grow out of the LCC crucible. Through the microscopic observation and XRD analysis, the electrodeposits at $440^{\circ}C$, which have a round shape, were identified as an intermetallic compound such as $UCd_{11}$. It can be concluded that the LCC electrowinning operation at $440^{\circ}C$ achieves the co-recovery of U and TRU without the formation of U dendrites.